Sony MHC-V77DW - Page 20

20
GB
MHC-V77DW.GB.4-596-076-13(1)
 Audio input and output jacks
Use an audio cable (not supplied)
to make either connection as
follows:
••
AUDIO/PARTY CHAIN OUT
L/R jacks
•—
Connect to the audio
input jacks of an optional
equipment.
•—
Connect to another audio
system to enjoy the Party
Chain function (page57).
••
AUDIO/PARTY CHAIN IN (TV)
L/R jacks
•—
Connect to the audio output
jacks of a TV or an audio/
video equipment. The
sound is output through this
system.
•—
Connect to another audio
system to enjoy the Party
Chain function (page57).
 Wireless LAN antenna
If you use the wireless network
function, set the antenna as
shown in the illustration.
Note
If a network (LAN) cable is
connected to the system, the system
automatically operates to establish
a wired LAN connection. If you wish
to use a wireless LAN connection, do
not connect a network (LAN) cable to
the system.
Hint
We recommend you to adjust the
wireless LAN antenna to 90 degrees
as in the illustration above for
maximum reception.
 FM ANTENNA terminal
Find a location and an
orientation that provide good
reception when you set up the
antennas.
Keep the antenna away from the
AC power cord (mains lead) and
the USB cable to avoid picking
up noise.
Extend the FM lead
antenna horizontally
 LAN (100) port
Use a LAN cable (not supplied) to
connect to a network equipment
(page 46).
 AC power cord (mains lead)
Connect the AC power cord
(mains lead) (supplied) to the
unit, then to the wall outlet.
To wall outlet
When the AC power cord (mains
lead) is connected, the system is
performing initialization. During
system initialization, “WELCOME”
appears on the display. While
the initializing is in progress, you
cannot turn on the system.
After initialization completes,
demonstration (page 25)
starts automatically. If you press
 to turn on the system, the
demonstration ends.