What’s this?
Use the cable to control devices that are not installed close
to each other if you want to control the devices with your
remote.
Please see “To control connected devices using the remote”
shown below for more information.
http://www.sony.net/helpguide/r/networkplayer/
See the online “Help Guide” for
a complete guide:
In the Box
Network Media Player (1)
Remote control (Remote) (1)
AC power cord (1)
Size AA batteries (2)
IR (infrared) Blaster cable (1)
Quick Setup Guide (1)
Getting Started (1)
Reference Guide and
other documents
Connection
step
1
Connect to your TV and Set Top Box/Digital Video Recorder*
Follow : A to connect to your TV directly.
: B to connect to your TV via AV Receiver
: C if your connection differs from the diagrams below.
A Direct to TV B To TV via AV Receiver C Other connection
TV
Set Top Box /
Digital Video Recorder
HDMI cable
(not supplied)
HDMI cable (not supplied)
TV
Set Top Box /
Digital Video Recorder
HDMI cable
(not supplied)
HDMI cable (not supplied)
AV Receiver See Help Guide for other connection patterns.
From your PC
http://www.sony.net/helpguide/r/networkplayer/
From your smartphone
* You can use this player without a Set Top Box/Digital Video Recorder, but doing so limits the availability of various TV viewing functions.
step
2
LAN cable (not supplied)
AC power cord
Connect to the power
source
Change the TV input
Switch the input selector on the TV
so that the signal from the player
appears on your TV screen.
Then, a screen that shows how to
setup your remote appears.
Note
This will only appear the first time you setup your
player.
Broadband
router*
1,
*²
*¹ When using wireless connection, you need to set the Network Setup in the Initial Setup Wizard (on step 4).
*² You can find MAC address in the Initial Setup Wizard (step 4) as needed. Select “Explain step” on “Connect to the Internet” screen.
Prepare for Network
connection
Skip to step 3 if you want to use a wireless
connection.
step
3
Connect to the power
source
step
4
Follow the directions for the Initial Setup
displayed on screen.
– The screen may stay dark for several seconds after the
Sony logo appears, then the Initial Setup screen appears.
– When the Initial Setup screen (on which a picture of
a player and a hand holding a remote is displayed)
appears, press and hold (Enter) to pair your remote
with the player.
– Complete the Network setup process, otherwise the Initial
Setup Wizard cannot be closed.
– It takes about 15 minutes to complete the Initial Setup.
Start the Initial Setup
Wizard
To control connected devices using the remote*
1
Quick Setup Guide
© 2012 Sony Corporation
Printed in China
4-453-328-11(1)
Install the player close to the connected devices.
This player is equipped with a built-in IR Blaster that sends remote commands to
various connected devices so you can control them with your remote.
If you still cannot control the connected device with the method above,
use the supplied “IR Blaster cable.”
Connect the IR Blaster cable to the player.
Place the IR Blaster close to the connected device, as illustrated on the right.
IR Blaster
cable
*
2
US
NSZ-GS7
Network Media Player
Sony Customer Support:
USA: http://esupport.sony.com/ | 1-800-222-SONY
Canada: http://esupport.sony.com/CA/ | 1-877-899-SONY
Please Call Before Returning the Product to the Store
*
1
This function only works when the player is turned on.
*
2
Location of the IR receiver may vary depending on the product you are using.
To Next Page
Need help?
General
