P
Paul ThompsonSep 1, 2025
Why do the REC LEVEL controls not work on my Sony PMW-EX30?
- TThomas AdamsSep 1, 2025
If the audio recording levels are set to the preset values, set 'Rec Level' in 'Audio Input' of the AUDIO SET menu to 'Manual'.
Why do the REC LEVEL controls not work on my Sony PMW-EX30?
If the audio recording levels are set to the preset values, set 'Rec Level' in 'Audio Input' of the AUDIO SET menu to 'Manual'.
How to freely set the initial time data value on Sony PMW-EX30 Camcorder?
If Regen mode or Ext regen mode is selected, set 'Mode' in 'Timecode' of the TC/UB SET menu to 'Preset'.
Why is data not superimposed on the monitor screen of my Sony PMW-EX30 Camcorder?
If the DISPLAY button is turned off, turn the DISPLAY button on. If superimposition is disabled, set 'HDMI/CMPNT/SDI Out DISP' or 'CMPST/ S Out Display' of the VIDEO SET menu to 'On'.
What to do if the device connected via i.LINK interface does not react as expected with my Sony Camcorder?
It sometimes takes time for the connected device to recognize the operation, wait for about 15 seconds. If the connected device still does not react, check the i.LINK cable, for example, by replugging it. Turn the power off, and connect the cable again. Change the i.LINK cable. If the input format (HDV or DVCAM) set on the connected device does not match with the output format, set the connected device to the same video format as that on this unit. If the video format is not set to SP1080/ 60i on this unit, set the video format on this unit to SP1080/60i.
What does error message E + Error code mean on Sony PMW-EX30 Camcorder?
If an internal error may have occurred, turn off the power and consult a Sony dealer. (If the power button is disabled, disconnect the AC power source.)
What to do if Sony DVR remote control is not working?
If your Sony DVR's remote control isn't working, it could be due to: * Remote control operation being disabled. Enable remote control operation. * The battery of the IR remote commander being exhausted. Replace the battery with a new one.
What does 'Media Near Full' mean on my Sony DVR?
The 'Media Near Full' message on your Sony DVR indicates that the free space on the SxS memory card is running low. Replace it with another card as soon as possible.