23
GB
Other Operations
1 Prepare the sound source, then
press VOLUME +/– to adjust the
volume.
2 Press TIMER MENU.
3 Press / repeatedly to select
“PLAY SET”, then press .
4 Set the time to start playback.
Press / repeatedly to set the
hour/minute, then press .
5 Use the same procedure as in
step 4 to set the time to stop
playback.
6 Press / repeatedly to select
the sound source you want, then
press .
7 Press "/1 to turn off the system.
To check the timer setting or
activate the timer again
1 Press TIMER MENU.
“TIMERSEL” flashes in the display
panel.
2 Press .
3 Press / repeatedly to select
“PLAY SEL”, then press .
To cancel the timer
Repeat the same procedure as above and
select “OFF” in step 3, and then press .
Notes
• The system turns on before the preset time. If
the system is turned on at the preset time or if
“STANDBY” flashes in the display panel, the
Play Timer will not play.
• Do not operate the system from the time the
system turns on until the playback starts.
Notes for the iPod/iPhone user
• Make sure the iPod/iPhone is not playing
when using the Play Timer.
• The Play Timer may not be activated
depending on the status of the connected iPod/
iPhone.
Changing the display
Press DISPLAY repeatedly while
the system is turned off.
Demonstration
The display changes and the indicator
flashes even when the system is turned
off.
No display (Power Saving Mode)
The display is turned off to conserve
power. The timer and clock continue to
operate.
Or,
iPod/iPhone Charging Mode
“CHARGING” appears and the system
continues to charge the iPod/iPhone.
Clock
The clock display automatically turns to
Power Saving Mode after 8 seconds.
Press DISPLAY repeatedly during
USB function when the system is
turned on.
You can view the information as follows:
• The elapsed playing time, file name and
folder name.
• The title, artist and album information.
Changing the display mode
Viewing information in the
display panel
To Next Page
Loading...
Need help?
General
