3
TABLE OF CONTENTS
Location of Parts and Basic Remote
Operations 4
Parts Description 4
Using the Lists 12
Chart of Lists 13
Selecting a Component 14
Selecting a Sound Field 15
Programming the Remote 15
Downloading Data From the Receiver 16
Other Operations 17
Additional Information 18
Troubleshooting 18
Specifications 19
Before You Use Your
Remote
Check that you received the following item with the
remote:
LR6 (size-AA) alkaline batteries (3)
Inserting batteries into the remote
Insert three LR6 (size-AA) alkaline batteries with the +
and – properly oriented in the battery compartment.
When using the remote, point it at the remote sensor g on
the receiver.
}
]
]
}
}
]
z
When to replace batteries
Under normal conditions, the batteries should last for about 3
months. When the remote no longer operates the receiver,
replace all the batteries with new ones.
Notes
• Do not leave the remote in an extremely hot or humid place.
• Do not use a new battery with old ones.
• Do not mix the alkaline batteries and other kinds of batteries.
This remote is designed for use with the alkaline batteries only.
• Do not expose the remote sensor of the receiver to direct
sunlight or lighting apparatuses. Doing so may cause a
malfunction.
• If you don’t use the remote for an extended period of time,
remove the batteries to avoid possible damage from battery
leakage and corrosion.
Setting up the remote
At the time of shipping, the remote has not been
customized to your receiver yet. Before you use the
remote for the first time, do the procedure below to set
up the remote so that it can control your receiver
properly.
1 Press 1/u on the receiver to turn it on.
2 Point the remote towards the receiver and press
SOUND FIELD, FUNCTION, or SUB.
and appear in the display window of the
remote while it communicates with the receiver and
identifies the receiver model.
When the communication ends, the remote is
customized and provides the operation lists that
match your receiver.
To Next Page
Loading...
Need help?
General
