14)
Refer all servicing to qualified service personnel.
Servicing is required when the apparatus has
been damaged in any
way,
such as power-supply
cord or plug is damaged, liquid has been spilled
or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture,
does not operate normally, or has been dropped.
The following FCC statement applies only to the
version
of
this model manufactured for sale in the
U.S.A. Other versions may not comply with FCC
technical regulations.
NOTE:
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part
15
of
the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and,
if
not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However,
there
is
no guarantee that interference will not occur
in a particular installation.
If
this equipment does
cause harmful interference
to
radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to
correct the interference by one or more
of
the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment
and receiver.
- Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV
technician for help.
CAUTION
You are cautioned that any changes or modifications
not expressly approved in this manual could void
your authority to operate this equipment.
The shielded interface cable recommended in this
manual must be used with this equipment in order
to
comply with The limits for a digital device pursuant
to
Subpart B
of
Part
15
of
FCC Rules.
This device complies with Part
15
of
the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
This equipment must not be co-located or operated
in conjunction with any other antenna or transmitter.
This equipment complies with FCC radiation
exposure limits set forth for uncontrolled equipment
and meets the FCC radio frequency (RF) Exposure
Guidelines in Supplement C to OET65.
This equipment should be installed and operated
with at least 20cm and more between the radiator
and person's body (excluding extremities: hands,
wrists, feet and ankles).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2)
this device must accept any interference, including
interference that may cause undesired operation
of
this device.
This equipment complies with IC radiation exposure
limits set forth for uncontrolled equipment and
meets the RSS-1 02
of
the IC radio frequency (RF)
Exposure rules.
This equipment should be installed and operated
with at least 20cm and more between the radiator
and person's body (excluding extremities: hands,
wrists, feet and ankles).
For
the
State
of
California,
USA
only
Perchlorate Material- special handling may apply,
See
www.dtsc.ca.gov/hazardouswaste/perchlorate
Perchlorate Material: Lithium battery contains
perchlorate.
For
customers
in
Europe
C
E:
CD
Notice for customers: the following information is
only applicable to equipment sold in countries
applying EU directives.
The manufacturer
of
this product is Sony
Corporation, 1-7-1 Konan Minato-ku, Tokyo,
108-0075 Japan.
The Authorized Representative for EMC and
product safety is Sony Deutschland GmbH,
Hedelfinger Strasse 61, 70327 Stuttgart, Germany.
To Next Page
Loading...
