SEL1855 (E 18-55mm F3.5-5.6 OSS)
2-4
HELP06
HELP07
1. Turn Zoom Cover Assy towards OVER TELE.
2. Insert the cam pins of 1 Group Moving Frame by fitting them to the cam grooves outside Zoom Cam Barrel.
(Fit the mark on 1 Group Moving Frame with "55" printed on Zoom Cover Assy.)
3. Turn Zoom Cover Assy towards WIDE.
Note:
Take notice that 1 Group Moving Frame, 2 Group Lens Assy and 3 Group Lens Assy may drop off if turn Zoom Cover Assy until it is in OVER TELE.
1. Turn Zoom Cover Assy towards OVER TELE.
2. Make F Lock Pin side just before you.
3. Insert the cam pins of 2 Group Lens Assy by fitting them to the cam grooves inside Zoom Cam Barrel Assy to make the notch of 2 Group Lens
Assy on the right side.
3. Turn Zoom Cover Assy towards WIDE.
Note:
Take notice that 2 Group Lens Assy and 3 Group Lens Assy may drop off if turn Zoom Cover Assy until it is in OVER TELE.
HELP08
1. Turn Zoom Cover Assy towards OVER TELE.
2. Pass the flexible board through Fixed Hold Barrel Assy at where the indicated R portion of Outer Barrel matching with the indicated R portion of
3 Group Lens Assy.
3. Insert the cam pins of 3 Group Lens Assy by fitting them to cam grooves.
Note:
Take notice that 3 Group Lens Assy may drop off if turn Zoom Cover Assy until it is in OVER TELE.
Cam Pin
Notch of 2 Group
Lens Assy
FLockPin
2 Group Lens Assy
Zoom Cover Assy
Cam Pin
55
Zoom Cover Assy
1 Group Moving Frame
1 Group Moving Frame
1 Group Moving Frame
3 Group Lens Assy
Zoom Cover Assy
Zoom Cover Assy
Cam Pin
In OVER TELE
R portion
Outer Barrel
To Next Page
Loading...
