SRS-D211
33
SRS-D211
SECTION 1
GENERAL
This section is extracted
from instruction manual.
LOCATING THE CONTROLS
SECTION 2
DIAGRAMS
For schematic diagrams.
Note:
• All capacitors are in µF unless otherwise noted. (p: pF) 50 WV or
less are not indicated except for electrolytics and tantalums.
• All resistors are in Ω and
1
/
4
W or less unless otherwise specified.
• C : panel designation.
• A : B+ Line.
• B : B– Line.
•Voltages are dc with respect to ground under no-signal conditions.
• no mark : Power on
•Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal production toler-
ances.
• Signal path.
F : AUDIO
• Abbreviation
CND : Canadian model
KR : Korean model
THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this necessary note is printed in each block.)
Note:
The components identi-
fied by mark 0 or dotted
line with mark 0 are criti-
cal for safety.
Replace only with part
number specified.
Note:
Les composants identifiés par
une marque 0 sont critiques
pour la sécurité.
Ne les remplacer que par une
piéce portant le numéro
spécifié.
For printed wiring boards.
Note:
• X : parts extracted from the component side.
• : Pattern from the side which enables seeing.
• Abbreviation
CND : Canadian model
KR : Korean model
POWER
ON
OFF
VOLUME
BASS
MIN MAX
MIN MAX
PHONES
POWER
VOLUME
PHONES
Controller
VOLUME:
Controls total volume level.
BASS:
Adjusts bass level (Subwoofer).
PHONES:
Connect the headphones for personal listening.
To Next Page
Loading...
