Sony SS-G9 - Page 2

S-G9
SERVICING NOTE
HANDLING THE SPEAKER
When changing the speaker location, disconnect
all connecting cords from the terminals. oe
The SS-G9 is quite heavy (87kg, 192 1b), and
should be handled by at least two persons, as shown
below. ae ee
To move the speaker a short distance.
“corner hole
ducted port
on the front
To move the speaker a greater distance.
at first, bring up
the bottom
corner hole
Q Then, grasp the rear portion.
Pi IN A ARB AN AS A A AN AL A AN SY RH Et SH SR LS AL RA MH RE Ra RA: A RN AT RA RN Re Rs A HN SL RA AR A AB AL AE A A DY A A RA AN A AE AA AA RAN A Ae A A RA A RB RN AA A RB A A A A I I
SECTION 1
DISASSEMBLY
1-1. REMOVAL
@ Follow the disassembly procedure in the numerical order
given.
FRONT GRILLE INSTALLATION/REMOVAL
To install.
Pushing up the &
grille slightly,
insert the pins.
To remove. @
NETWORK CHECK/REPAIR
Note: Remove the network holder not to cut
the lead wires. 5)
Perform the checking
or repairing.
@) Support the network |
holder with a strong
(Cer (77)
holder, network
NZD So
“2
Ss
RS
'S,
S;
a,
Ss
S
=F
@
screw, hexagon socket;
6x50 (six screws)
Use an L-shaped >
real wrench. 7°
@ screw, hexagon socket;
6x50 (six screws)
Use an L-shaped '
hexagonal wrenc