EasyManua.ls Logo

Sony SS-V230 User Manual

Sony SS-V230
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
SA-VE230/WMS230/
SS-CN230/V230
US Model
Canadian Model
SERVICE MANUAL
MICRO SATELLITE SYSTEM
The SA-VE230 system consists of one unit
of SA-WMS230, one unit SS-CN230 and
four units of SS-V230.
SPECIFICATIONS
Photo: SA-WMS230
Photo: SS-CN230
Photo: SS-V230
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION :
with 8 loads both channels driven, from 20 - 150 Hz; rated
50 W per channel minimum RMS power, with no more than
0.8% total harmonic distortion from 250 mW to rated output.
SS-V230 Front and rear speakers
Speaker system Full range, magnetically shielded
Speaker units 5
× 9 cm (2 × 3
5
/8 in.), cone type
Enclosure type Bass reflex
Rated impedance 8
Power handling capacity
Maximum input power: 100 W
Sensitivity level 86 dB (1W, 1m)
Frequency range 90 Hz - 20,000 Hz
Dimensions (w/h/d) Approx. 70 × 151 × 126 mm
(2
7
/8 × 6 × 5 in.), including front
grille
Mass Approx. 550 g (1 lb 3 oz) each
SS-CN230 Center speaker
Speaker system Full range × 2, magnetically
shielded
Speaker units 5
× 9 cm (2 × 3
5
/8 in.), cone type
Enclosure type Bass reflex
Rated impedance 8
Power handling capacity
Maximum input power: 120 W
Sensitivity level 88 dB (1W, 1m)
Frequency range 90 Hz - 20,000 Hz
Dimensions (w/h/d) Approx. 301 × 70 × 126 mm
(11
7
/8 × 2
7
/8 × 5 in.), including front
grille
Mass Approx. 1.1 kg
(2 lb 7 oz)
SA-WMS230 Subwoofer
System
Speaker system Active subwoofer, magnetically
shielded
Speaker unit Woofer : 16 cm (6
3
/8 in.),
cone type
Enclosure type Advanded SAW type
Continuous RMS power output
(8 , 20 - 150 Hz, 0.8 % THD)
50 W
Reproduction frequency range
28 Hz - 200 Hz
High frequency cut-off frequency
200 Hz
Input
LINE IN (input pin jack)
General
Power requirements 120 V AC, 60 Hz
Power consumptions 45 W
Dimensions (w/h/d) Approx. 205 × 385 × 385 mm
(8
1
/8 × 15
1
/4 × 15
1
/4 in.), including
front grille
Mass Approx. 10.5 kg
(23 lb 2 oz)
Supplied accessories
Foot pads (20)
Audio connecting cords (2 phono to 2 phono) (3)
Monaural connecting cord (1 phono to 1 phono) (1)
Speaker connecting cords, 10 m (32 ft
9
3
/4 in.) (2)
Speaker connecting cords, 2.5 m (8 ft
2
1
/2 in.) (3)
Design and specifications are subject to change
without notice
Ver 1.0 2000.2
Question and Answer IconNeed help?

Do you have a question about the Sony SS-V230 and is the answer not in the manual?

Sony SS-V230 Specifications

General IconGeneral
BrandSony
ModelSS-V230
CategorySpeaker System
LanguageEnglish

Summary

Specifications

SS-V230 Front and rear speakers

Details for the SS-V230 front and rear speaker system, including speaker units, impedance, and power handling.

SS-CN230 Center speaker

Specifications for the SS-CN230 center speaker, covering speaker units, enclosure type, and input power.

SA-WMS230 Subwoofer

Technical data for the SA-WMS230 subwoofer, including RMS power, frequency range, and enclosure type.

General Specifications

General specifications for the system, including power requirements, consumption, dimensions, and mass.

Supplied Accessories

List of accessories supplied with the system, such as foot pads and various audio connecting cords.

Safety Check-out

Leakage

Procedure for checking AC leakage from exposed metal parts to earth ground.

Safety-Related Component Warning

Warning regarding critical safety components identified by mark ▲.

Section 1 Diagrams

Notes for Printed Wiring Boards and Schematic Diagrams

Notes on interpreting printed wiring boards and schematic diagrams, including component notations.

IC Block Diagrams

Block diagrams illustrating the function of integrated circuits used in the system.

Circuit Boards Location

Diagram showing the location of circuit boards within the SA-WMS230 unit.

Schematic Diagram (SA-WMS230)

Detailed schematic diagram for the SA-WMS230, illustrating the main, control, and power boards.

Printed Wiring Board (SA-WMS230)

Layout of the printed wiring boards for the SA-WMS230, showing component placement.

Section 2 Exploded Views

SA-WMS230 (1)

Exploded view of the SA-WMS230 speaker system, showing mechanical parts and their assembly.

SA-WMS230 (2)

Second part of the exploded view for the SA-WMS230, detailing additional components and boards.

SS-CN230

Exploded view of the SS-CN230 center speaker, illustrating its construction and parts.

SS-V230

Exploded view of the SS-V230 speaker, showing its assembly and individual components.

Section 3 Electrical Parts List

Related product manuals