What to do if the remote control for my Sony SS-WP7M Home Theater System does not function?
If the remote control for your Sony Home Theater System isn’t working, try these steps: * Point the remote control at the remote control sensor on the receiver. * Remove any obstacles between the remote control and the receiver. * Replace the batteries in the remote control with new ones if they are weak.
What to do if there is no sound from a specific equipment connected to my Sony Home Theater System?
If there is no sound from a specific equipment connected to your Sony Home Theater System, check the following: * Ensure the equipment is correctly connected to the audio input jacks for that equipment. * Verify the connecting cord(s) are fully inserted into the jacks on both the receiver and the equipment. * Check the INPUT MODE. * Check the setting of “AUDIO.OUT” in the HDMI menu. * Confirm the equipment is correctly connected to the HDMI jack for that equipment. * Note that you cannot listen to Super Audio CD by connecting HDMI.
Why are the left and right sounds unbalanced or reversed on my Sony SS-WP7M Home Theater System?
If the left and right sounds are unbalanced or reversed on your Sony Home Theater System, check that the speakers and equipment are connected correctly and securely. You can also adjust the level parameters using the LEVEL menu.
What to do if no image appears on my Sony SS-WP7M Home Theater System TV?
If no image appears on the TV when using your Sony Home Theater System, try the following: * Select the appropriate input using the input buttons. * Set your TV to the appropriate input mode. * Move your audio equipment away from the TV. * Ensure cables are correctly and securely connected to equipment. * Set up the playback equipment, depending on the equipment. * Use a High Speed HDMI cable, especially for 1080p, Deep Color, or 3D transmission.
Why does my Sony SS-WP7M turn off automatically?
Your Sony Home Theater System receiver might be turning off automatically because “AUTO.STBY” is set to “STBY ON”, or the Sleep Timer function is active.
What does USB FAIL mean on my Sony Home Theater System and what to do?
If your Sony Home Theater System displays “USB FAIL”, it indicates: * An over current from the USB port was detected. Check the USB device, then unplug it and turn on the power again. * Irregular current is output to the speakers, or the receiver is covered and ventilation holes are blocked. Remove the object covering the upper panel of the receiver, check the speaker connection, and turn on the power again.
What to do if recording cannot be carried out on my Sony Home Theater System?
If you cannot record with your Sony Home Theater System, please check the following: * Verify that the equipment is connected correctly. * Select the source equipment using the input buttons. * Note that audio input signals via HDMI IN and DIGITAL IN jacks cannot be recorded. * The source may contain copyright protection to prevent recording.
Why is the FM reception poor on my Sony SS-WP7M Home Theater System?
To improve poor FM reception on your Sony Home Theater System, use a 75-ohm coaxial cable to connect the receiver to an outdoor FM antenna.
General| Type | Subwoofer |
|---|---|
| Power Output | 100 W |
| Frequency Response | 28 Hz - 200 Hz |
| Color | Black |
| Speaker System | Bass reflex |
| Dimensions (W x H x D) | 280 x 380 x 380mm |
To Next Page