Need help?Do you have a question about the Sony STR-AV1020 and is the answer not in the manual?
General| Frequency Response | 10Hz to 50kHz |
|---|---|
| Speaker load impedance | 8 ohms |
| Video Connections | composite |
| Power Output | 100 watts per channel into 8Ω (stereo) |
| Input Sensitivity | 2.5mV (MM) |
| Dimensions | 430 x 150 x 390mm |
Diagram and instructions for connecting VCRs and LD players to the receiver and monitor TV.
Instructions for connecting FM and AM antennas, including tips for areas with difficult reception.
Guide for connecting speaker systems and the AC power cord, with power outlet cautions.
How to adjust volume, mute sound, and set the left/right sound balance for optimal listening.
Using DBFB for bass enhancement and selecting speaker systems (A, B, A+B) or headphones.
Steps to select program sources and activate the receiver's demonstration mode.
Instructions for directly entering a frequency to tune into FM or AM radio stations.
Method for automatically scanning and stopping at receivable radio stations.
Procedure to memorize up to 30 FM/AM stations in a desired sequence.
Method A to tune into a preset station using PRESET TUNING +/- buttons.
Method B to tune into a preset station using SHIFT and numeric buttons.
How to create and assign up to 5-character index names to preset stations for categorization.
Steps for recording audio from sources onto tape or DAT decks.
Instructions for transferring recorded audio from one tape deck/DAT deck to another.
Procedure for editing video tapes using two VCRs and the receiver.
How to add new audio from various sources onto a video tape during editing.
Troubleshooting steps for issues with FM/AM tuning, auto-tuning, and preset tuning.
Troubleshooting for no sound, low volume, unbalanced channels, or abrupt loss of sound.
Solutions for severe hum or noise, reversed speaker sound, and lack of bass.
To Next Page