Sony STR-AZ3000ES - Factory Default Settings; Cancel Resetting; Resetting via Home Menu

29
EN
STR-AZ7000ES/STR-AZ5000ES/STR-AZ3000ES
5-037-019-11(1)
Reverting to the factory default settings
If the receiver does not operate properly, reset the receiver as
follows.
, ///
HOME
1 Press HOME.
The home menu is displayed on the TV screen.
Watch
Listen
Custom Preset
Sound Eects
Zone Controls
Setup
2 Press / repeatedly to select [Setup], and then press .
3 Press / repeatedly to select [Resetting], and then press .
4 Press / repeatedly to select [All Settings], and then press
.
5 Press / repeatedly to select [Start], and then press .
To cancel resetting
Select [Cancel] in step 5.
If you cannot perform resetting using the home menu
1 Press and hold  (power) on the receiver for more than 10
seconds.
The settings return to their initial status.
Notes
•It takes a few minutes for the memory to be cleared completely. Do not
turn the receiver off until “RESET” appears on the display panel.
•By resetting, the link with the wireless subwoofer and rear speakers (not
supplied) may be lost.
In this case, reconnect them by referring to their operating instructions.