Need help?Do you have a question about the Sony STR-AV970X and is the answer not in the manual?
General| Speaker Load Impedance | 8 ohms |
|---|---|
| Power Output | 100 watts per channel (8 ohms) |
| Tuning range | FM: 87.5-108MHz, AM: 522-1611kHz |
| Total Harmonic Distortion | 0.09% (20Hz-20kHz, 8 ohms) |
| Input Sensitivity | 150mV (line), 2.5mV (MM phono) |
| Video Connections | Composite video input/output |
| Dimensions | 430 x 150 x 380mm (W x H x D) |
| Input Impedance | 47 kOhms |
Prevent fire/shock by avoiding moisture and opening the unit.
Use caution with plugs and blade exposure to prevent shock.
Covers electrical safety, handling, and operating procedures.
Ensure adequate air circulation and avoid heat, sunlight, dust, vibration, or shock.
Connect power last, ensure full insertion of cables, color-coded jacks.
Connect FM/AM antennas, record player, CD player, DAT deck, tape deck, speakers.
Diagrams for connecting VCRs, LD player, and monitor TVs.
Instructions for connecting wire antenna or 75-ohm coaxial cable.
Connecting loop antenna and ground wire for AM reception.
Connecting front, rear, center, and DRLC speakers.
Connecting to AC outlet; caution on power consumption.
Entering frequencies directly for FM and AM stations.
Automatically scans for stations and stops at receivable signals.
Memorizing up to 30 FM/AM stations in sequence.
Recalling preset stations using Method A or Method B.
Selecting source and setting tape deck for recording.
Editing video tapes using VCRs and selecting playback/record modes.
Adding desired sound from audio sources to video tapes during editing.
Adding desired sound from audio sources to video tapes during editing.
Adjusting rear and center speaker levels and using test tone signals.
Solutions for no FM reception, STEREO indicator problems, and tuning issues.
Troubleshooting for equalizer adjustment and surround effect problems.
Problems with no sound, low volume, channel imbalance, loss of sound, reversed speakers, hum, and noise.
Editing video tapes using VCRs and selecting input sources.
Adding audio from program sources during video tape editing.
Editing video tapes using VCRs and selecting input sources.
Adding audio from program sources during video tape editing.
To Next Page
