Sony STR-AV970X - Installing the Receiver; Installation Notes; Remote Commander Battery Installation

Notes on Installation
To prevent internal heat buildup in the unit,
place the unit in a location with adequate air circulation.
Do not install the unit:
— near heat sources such as radiators or air ducts.
—
in
a
place
subject
to
direct
sunlight,
excessive
dust,
mechanical
vibration
or
shock.
Do not place anything on top of the cabinet.
The
top
ventilation
holes
must
be
unobstructed
for
the
proper
operation
of
the
unit
and
to
prolong
the
life
of
its
components.
Do not throw away the carton and packing material!
It
will
be
an
ideal
container
when
transporting
the
system
for
repair
work,
etc.
Loading the Remote Commander with Batteries
Before operating remote commander, install the batteries as shown.
L
2 Two size AA (R6) batteries
To avoid damage caused by battery leakage and
corrosion
When the commander will not be used for a long time,
remove the batteries.
Battery life
Normal
operation
can
be
expected
about
a
half
year
using
Sony
SUM-3
(NS),
and
a
year
using
Sony
AM-3
(NW)
alkaline
batteries.
When
the
batteries
are
run
down,
the
remote
commander
will
not
operate
the
unit.
In
this
case,
replace
batteries
with
new
ones.
Changing the AM tuning interval
The AM tuning interval is preset to 10 kHz. To use the
receiver
where
the
frequency
allocation
system
is
based
on a 9 kHz interval, make the following adjustments.
1 Turn on the power and tune in any AM station.
2. Turn off the power.
3 Press the POWER button while pressing the “+”
PRESET TUNING button.
To reset the AM tuning interval, repeat the above steps.
Caution
When the interval is changed, all preset stations which you have
memorized
will
be
erased.
After
changing
the
interval,
be
sure
to
preset the stations again.