Sony TA-E1000ESD - Page 27

Recording program sources while listening to/watching another
This unit has separate circuits for line output and for
recording, So you can record a program source while
listening to/watching another.
Main
unit
Remote
commander
Select the program source to be recorded.
If you want to combine a video image and the VIDEO 1 MIX
[weer |~_ Fx] <@ 1 sound from another audio source, press MIX ie 3 ~ C
to select these sources independently(refer to
page 22).
Press SET. GixeXeVUiHS9 appears in the
4 2 display window and the displayed
combination of audio/video recording outputs
SET is preset for recording.
3 Play back the selected program source(s) to
be recorded.
Set the video or tape deck into the recording
mode. Press the desired input function
button to select the program source to be
listened to/watched.
To check the preset recording outputs To record a listening program source
Press CHECK to display them in the display window. The Press SET to turn off the QSXCKeUMESTSg in the display
input function display will resume after a few seconds. window. The program source being listened to/watched is
output from the REC OUT jacks.
You cannot preset the recording output in the following
cases Monitoring while recording
e When you are listening to digital input sources(COAXIAL, When a 3-head tape recorder is used, the recorded result
OPTICAL 1, or OPTICAL 2). can be monitored. When the recording is done on a tape
e When you turn on the effect recording function (refer to recorder connected to the TAPE 1 or TAPE 2 jacks, the
page 26). recorded sound can be monitored by selecting TAPE 1 or
TAPE 2, respectively.
27