Sony TA-E2000ESD - Page 44

Calling up the Sound Field Setting
Press the PRESET/USER button.
USER appears in the display.
Press the SOUNDFIELD PROGRAM button to
select the desired number.
On the PRESET/USER button and sound field setting
There are ten sound fields in each position PRESET and
USER of the PRESET/USER button. Ten sound fields in
the PRESET position are already preset at the factory;
you can store your ten sound fields in the USER
position. As your sound fields are automatically stored
in the USER position, it is not necessary to set the
PRESET/USER button. At the time of shipping, the same
sound fields are stored in both PRESET and USER
positions. To change the title of a sound field in the
USER position, refer to the next page.
When you store a new sound field in the preset number
already stored
The previous sound field will be erased and the new
one will be stored.
To return to the initial settings
1 Press the POWER switch to turn the amplifier
off.
While holding down the CLEAR button, press
the POWER switch to tum the amplifier on
again.
Sound fields stored, assignment of digital inputs
to analog input buttons (see page 28), and titles
assigned to input select buttons (see page 45)
will be initialized.
Even if the AC power cord is disconnected
The stored data is maintained for approximately two
weeks.