(Jetting .StarteO
Connecting an antenna/cable TV system
without a VCR
If your cable company requires you to connect a cable
box, make the connection as follows:
Cable or antenna
Incoming Cable
(Rear of W)
VHF/UHF
Although you can u_c either an indoor antenna or
outdoor antenna with your TV, we recommend you to
connect an outdoor antenna or a cable TV system to get
better picture quality.
How to connect different types of
cables
The illustrations below show the examples of
connecting cable to the TV directly.
A
* VHF only
or
• VHF/UHF
or
• cable
75-ohm coaxial cable
(Rear of TV)
VHF/UHF
B
(Rear of TV)
• VHF only 300-ohm twin lead cabl VHF/UHF
• UHF only
or
• VHF/UHF Antenna connector
Cable box
Cable
IN I
(Rear of TV)
VHF/UHF
i OUT
Cable box
Pay cable TV systems use scrambled or encoded signals
requiring the cable box* in addition to the normal cable
connection.
* The cable box will be supplied by the cable company.
Note
• You cannot watch the signal through AUX connector as a
window picture.
C 75-ohm coaxial cable
• VHF __:=
(Rear of TV)
and __UHF
EAC-66 UIV mixer
• UH F -----_ _ (not supplied)
300-ohm twin lead cable
Notes
• Most VHF/UHF combination antennas have a signal splitter.
Remove the splitter before attaching the appropriate connector.
• If you use the U/V mixer, snow and noise may appear in the
picture when viewing cable TV channels over 37 (W +1).
Getting Started I 5
To Next Page
