Connecting an antenna/cable TV system with a VCR
"[o connect your VCR to the TV, first check the model
number of your TV and select the corresponding
connection. For details on connection, see the
instruction manual of your VCR. Before making
connection, disconnect the AC power cords of the
equipment to be connected.
After making these connections, you will be able to do
the following:
° View the playback of video tapes
° Record one TV program while viewing another
program
Without a cable box
(Rear of TV)
Cable
•_ VCR
_'_OUT AUDIO VIDEO
ClIZ]l._ ,N ,,NEI_--_--_
OUT L___
?
VHF/UHF
]
1
VMC-810S/820S
(not supplied)
Note
• To connect a monaural VCR, connect the audio output of the
VCR to AUDIO-L (mono) of VIDEO 1 IN on the TV.
To an S video equipped VCR without a cable box
A_
T-
VIDEO (yellow)
-- AUDIO-L (white)
AUDIO-R (red)
• KV-27V10/29V10C/29V10M/32S10 only
If your VCR has an S video output jack, hook up as
follows and then set S VIDEO to ON on your TV
(page 12). (It is set to ON at the factory.)
Cable
6 IGetting Started
VCR
I [_OUT AUDIO VIDEO SVIDEOI
I
VHF/UHF
YC-15V/30V
(not supplied)
J
RK-74A
(not supplied)
(Rear of TV)
S VIDEO
..... AUDIO-L (white)
AUDIO-R (red)
To Next Page
