Need help?Do you have a question about the Sony Trinitron PVM-14L2MD and is the answer not in the manual?
General| Screen Size | 14 inches |
|---|---|
| Display Type | CRT |
| Aspect Ratio | 4:3 |
| Input Connectors | BNC |
| Technology | Trinitron |
| Display Colors | 16.7 million |
| Video Inputs | Composite, RGB |
| Audio Inputs | RCA |
Controls video signal display, including input connector, sync, system, and preset white balance settings.
Defines offset type for COMPONENT and NTSC signals, specifying values for component and NTSC offsets.
Switches monitor functions to an 'on' state or simulates a key press. Lists specific functions and their actions.
Toggles specific monitor functions to an 'off' state. Details functions and the actions taken when turned off.
Sets color system display and language. Defines values for selected language and color system display modes.
Configures Chroma Setup items. Defines ON, OFF, and Auto Adjust settings for Chroma.
Defines RGB Mode selection for the monitor. Specifies video and sync signal settings for Option 1 and RGB/Component inputs.
Stores white balance data into volatile RAM. Includes color temperature range, data elements, and specific white balance values.
Stores preset data (Chroma, Phase, etc.) into volatile RAM. Specifies user setting switch, data elements, and preset values.
Stores data into NV RAM from volatile memory. Specifies NV RAM area, data elements, and data items to be saved.
Adjusts User Preset data including Chroma, Phase, Brightness, Aperture, Contrast, and Volume. Specifies data elements and adjustment values.
Specifies Sub Control data for the monitor. Details data elements such as Contrast, Brightness, Phase, and Chroma values.
Restores monitor data to factory defaults. Specifies data elements to be restored, including Sub Control, User Preset, and White Balance.
Obtains White Balance data stored in monitor registers. Requires the White Balance data request bit to be set.
Obtains Preset data stored in monitor registers. Requires the least significant bit of the first data byte to be set.
Senses the monitor's current operation status. Allows specifying which data items should be included in the reply.
Obtains Sub Control data such as Brightness, Chroma, Phase, and Contrast values from the monitor.
Obtains lesser details of monitor status. Allows specifying items like Switch Condition, RGB Mode, Menu, and Display for the reply.
Obtains the current status of the monitor's remote control ability. The monitor replies regardless of the actual remote state.
Replies to status request commands. Includes elements of reply data and the actual reply data for requested items.
Sends required White Balance data to the remote controller. Includes specification and the actual reply data.
Sends Preset data stored in the monitor registers to the remote controller. Includes specification and the actual reply data.
Informs the remote control of Sub Control data values. Lists Brightness, Chroma, Phase, and Contrast values.
Provides lesser details of monitor status. Includes elements of reply data and the actual reply data for requested items.
Indicates that a command was correctly received and executed by the monitor.
Specifies problems found with the serial communication port. Lists various error types like timeout, framing, parity, and checksum errors.
To Next Page
