UWP-D11
CHASSIS & DISPLAY OVERVIEW - TRANSMITTER
TRANSMITTER DISPLAY
BODY-PACK TRANSMITTER (UTX-B03)
1
2
3
4
5
6
7
8
9
10
11
Antenna
Power Indicator - Displays the battery level
AUDIO Indicator
Audio Input Connector - Connect the supplied lavalier microphone
POWER/MUTING Button - Turns the power on/off. You can also use this button to turn the muting function on/off.
USB Connector - You can power the unit using a USB cable (either portable power supply or connected to the mains.
Battery Compartment
+ or - Button - Use these to operate the menu
Display Section
SET Button - Use this to set values/functions in the menu
Infrared Detector - Receives the frequency and compander mode set on the tuner
Indicator Display Status
ON (Green) Sufcient battery level
Flashing (Green) Battery is getting low
Off Power is off or battery is empty
Indicator Display Status
ON (Red) Audio input level is too high
ON (Green) Audio input level is appropriate
Off There is no audio input or the input level is too low
Flashing (Orange) Audio is muted (i.e. disabled)
A
B
F
G
D
E
C
RF Transmission Indicator - Displays the current transmission status
RF Transmission Power Indicator - Indicates the current transmis-
sion power setting.
Battery Level Indicator - Displays the battery level.
Menu Display Section - Displays various functions. Press the + and -
buttons to switch functions.
Peak Indicator - Lights up when the audio signal is 3dB below the lev-
el at which distortion begins as a warning of excessive input level.
Input Level Indicator - Displays the input level status (MIC or LINE)
Audio Input Level Meter - Displays the audio input level.
To Next Page
Need help?
General
Weight and Dimensions
