Sony WM-A52 - Page 2

WM-A52/B52
NOTE ON REPAIR
, This model is waterproof, so be sure to confirm water-
proofing after reapir.
WATERPROOF CHECK
(1) Insert batteries or a cassette tape in the set.
(So that it will sink.) 3
(2) Place in more than 30 cm of water for 30 minutes.
(Close DC jack and packing firmly.)
water
more than 30cm
(11-7/8 inch)
(3) Remove from the water after 30 minutes and wipe off
all moisture.
(4) Check all operations. (If water has entered, abnormal
operation will occur.)
(5) Open the cassette case and wipe off all moisture on the.
packing and case sections touching the packing.
packing
section
touching the packing
(7)
When
waterproofing
is
confirmed,
mount
the
orna-
mental
sheet
and
ornamental
plate
assy
(A).
(Wipe
off
the
water
on
the
screw
to
prevent
rusting.
)
|
IF
LEAKAGE
OCCURS
DURING
WATERPROOF
CHECK:
|
aE
Be
Dry
the
mechanism
section
and
amp
board,
jack,
etc.
with
a
hairdryer,
perform
waterproofing
procedures
again
and
recheck
starting
with
step
(1).
Saget is eee aay