SERVICE MANUAL
Sony Corporation
Published by Sony Techno Create Corporation
XM-GTR2202
STEREO POWER AMPLIFIER
9-889-724-02
2011H33-1
©
2011.08
US Model
Canadian Model
AEP Model
UK Model
E Model
Ver. 1.1 2011.08
SPECIFICATIONS
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC DISTORTION
220 watts per channel minimum continuous average power into 4 ohms,
both channels driven from 20 Hz to 20 kHz with no more than 1% total
harmonic distortion per Car Audio Ad Hoc Committee standards.
Other Specifi cations
Circuit system OTL (output transformerless) circuit
Pulse power supply
Inputs RCA pin jacks
High level input connector
Outputs Speaker terminals
Through out pin jacks
Suitable speaker impedance
2 8 (stereo)
4 8 (when used as a bridging amplifi er)
Maximum outputs 440 W 2 (at 4 )
650 W 2 (at 2 )
1,400 W (BTL) (at 4 )
Rated output (supply voltage at 14.4 V, 20 Hz 20 kHz, 1% THD + N)
220 W 2 (at 4 )
270 W 2 (at 2 )
540 W (BTL) (at 4 )
Frequency response 10 Hz 50 kHz (
–3
dB)
Input level adjustment range
0.3 6.0 V (RCA pin jacks)
1.2 12.0 V (High level input)
Low-pass fi lter 50 Hz 300 Hz, 12 dB/oct
Subsonic fi lter 6 Hz 70 Hz, 12 dB/oct
Low boost 0 10 dB (40 Hz)
Power requirements 12 V DC car battery (negative ground)
Power supply voltage
10.5 16 V
Current drain at rated output: 50 A (at 4 )
Remote input: 1 mA
Dimensions Approx. 424 55 280 mm
(16
3/4 2 1/4 11 1/8 in) (w/h/d) not incl.
projecting parts and controls
Mass Approx. 3.6 kg (7 lb 15 oz) not incl. accessories
Supplied accessories
Mounting screws (4)
High level input cord (1)
Protection cap (1)
Design and specifi cations are subject to change without notice.
+0
Dimensions / Dimensions / Dimensiones
Unit: mm (in)
Unité : mm (po)
Unidad: mm
ø 6 (
1
/
4
)
264 (10
1
/
2
)
424 (16
3
/
4
)
354 (14)
55
(2
1
/
4
)
354 (14)
280 (11
1
/
8
)
To Next Page
Need help?
General
