If the headset units are charged while they are wet with sweat, etc., the charging ports will corrode. Before charging,
wipe off any moisture with a soft dry cloth and leave to dry in room temperature.
Repairs in case of a malfunction without care are not covered by the free warranty.
If the charging port of the headset gets dirty, wipe it clean with a soft dry cloth.
Do not wash pants or shirts with the headset left in a pocket.
If the headset is cracked or deformed, refrain from using the headset near water, or contact your nearest Sony
dealer.
5-036-709-11(2)
Copyright 2022 Sony Corporation
Turn the microphone hole downward and gently tap it about 10 times on a dry cloth, etc. to remove any water
collected inside.
3.
Leave the headset to dry in room temperature.4.
To Next Page
Loading...
