Content
A.1. - EC declaration of conformity 4
A.2. - General instructions 4
A.3. - Explanation of symbols 4
A.4. - Changes to the unit 5
A.5. - Warranty and liability 5
B.1. - Specifi cations 6
B.2. - Temperature resistance table
for Pt1000 sensors 6
B.3. - About the controller 7
B.4. - Versions 7
B.5. - Scope of supply 8
B.6. - Disposal and pollutants 8
B.7. - Hydraulic variants 9
C.1 Wall installation 10
C.2 Electrical connection 11
C.3 Installing the temperature sensors 13
D Terminal connection diagrams 14
E.1 Display and Input 19
E.2 Parametrisation 20
E.3 Free commissioning 20
E.4 Menu sequence and menu structure 21
1. - Measurement values 22
2. - Statistics 23
2.1. - Operating hours 23
2.2. - Average temperature difference T 23
2.3. - Heat output 23
2.4. - Graphic overview 23
2.5. - Message log 23
2.6. - Reset / clear 23
3. - Display mode 24
3.1. - Schematic 24
3.2. - Overview 24
3.3. - Alternating 24
3.4. - Eco Mode 24
4. - Operating modes 25
4.1. - Automatic 25
4.2. - Manual 25
4.3. - Off 25
5. - Settings 26
6. - Protective functions 29
6.1. - Seizing protection 29
6.2. - Frost protection 29
6.3. - System protection 30
6.4. - Collector protection 30
6.5. - Col.- Alarm 30
6.6. - Recooling 31
6.7. - Anti-Legionella 32
7. - Special functions 33
7.1. - Program selections 33
7.2. - Signal V1 33
7.2.1. - Type of signal 34
7.2.2. - Profi le 34
7.2.3. - Output Signal 34
7.2.4. - PWM off 35
7.2.5. - PWM on 35
7.2.6. - PWM Max 35
7.2.4 - 0-10V off 35
7.2.5 - 0-10V on 35
7.2.6 - 0-10V Max 35
7.2.7. - Speed when „On“ 36
7.2.8. - Show signal 36
7.3. - Speed control 38
7.3.1. - Speed control mode 38
7.3.2. - Purging time 39
7.3.3. - Sweep time 39
7.3.4. - max. speed 39
7.3.5. - min. speed 39
7.3.6. - Setpoint 39
7.4. - Time and Date 40
7.5. - Sensor calibration 40
7.6. - Commissioning 40
7.7. - Factory settings 40
7.8. - Heat quantity 41
7.8.1. - Heat metering 41
7.8.2. - AF type 41
7.8.3. - Glycol portion 41
7.8.4. - Flow rate 41
7.8.5. - T Offset 41
7.9. - Starting aid 42
7.10. - Daylight saving time 42
8. - Menu lock 43
9. - Service values 44
10. - Language 44
Z.1 Malfunctions with error messages 45
Z.2 Replacing the fuse 46
Z.3. Maintenance 47
To Next Page
Loading...
