Need help?Do you have a question about the Soulution 701 and is the answer not in the manual?
Describes the ideal amplifier characteristics and the 701's proximity to it.
Explains the bridged amplifier design and mechanical construction for balance.
Details the signal path, amplification stages, and output stage components.
Describes the switched mode power supplies and dedicated power supplies used.
Keep this user manual for reference and follow all safety advices.
Use grounded cords and unplug during storms or extended absence.
Disconnect from mains before cabling to prevent damage or hearing loss.
Use specified equipment and exercise caution during transport.
Keep original packing for future transport and allow warming up to prevent condensation.
Avoid operating in closed cabinets, high temperatures, or humidity.
Use a soft, dry, non-abrasive towel; avoid solvents or liquids.
Service by qualified person needed for damaged cables, liquid ingress, or malfunction.
Lists the main product, power cord, and user manual included in the package.
Sets the operation mode ('Mono' or 'Dual'), activated after unplugging.
Connect speakers here, ensuring tight fit and undamaged cables.
Connects to preamplifier's LINK-Out for system networking.
Allows setting Start-Mode, Start-Input, and display Brightness.
Enables remote control and information exchange via RS232 interface.
Shows serial number and nominal power rating of the unit.
Power button controls ON/OFF state; mutes loudspeaker terminals when OFF.
Activates the LINK function; allows switching unit on/off via front panel.
Defines the active input; mutes inactive inputs.
Shows all relevant operating information.
Soft clip circuit activates at high input levels to prevent signal distortion.
Switches off automatically if output current exceeds 80 A to prevent damage.
Monitors power transistors and switches off if operating temperature is exceeded.
Mains connection fuse protects against high power consumption; replace with same type.
Check cabling and fuse if the display shows no output.
Verify cabling, input selection, preamplifier, and source component status.
Address PS-A, PS-B, or PS60 FAIL errors by restarting or checking supply.
Identifies AMP1 and AMP2 FAIL errors indicating channel issues.
Addresses DATA-CON errors indicating broken communication to audio channels.
Disconnect mains and contact dealer if error cannot be identified.
To Next Page
General