What to do if error ERR1...3 appears when switching Soulution Amplifier from OFF to ON?
If error ERR1...3 appears when switching the Soulution Amplifier from OFF to ON, first check the cabling, the mains voltage for over/under voltage, and the level of the input signal. If the error persists, contact your Soulution dealer.
Why is there no music coming from my Soulution 710 Amplifier?
If there is no music from the Soulution Amplifier, check the cabling to your preamplifier and the loudspeakers. Also, verify whether the correct input (SYM/ASYM) is activated, whether the preamplifier is switched on, and if the right source has been selected. Check whether an output signal is available at your source and preamplifier, ensuring Mute and Pause are off.
What to do if error ERR1...3 occurs in operation with Soulution 710?
If error ERR1...3 occurs in operation with the Soulution Amplifier, switch off the mains for 15 seconds and then switch it back on. If the error continues, please contact your Soulution dealer.
What to do if error ERR1...3 appears after switching on Soulution 710?
If error ERR1...3 appears after switching on the Soulution Amplifier, switch off the mains for 15 seconds and switch it on again. If the error has not disappeared please contact your Soulution dealer.
How to fix no display on Soulution Amplifier?
If there is no display on the Soulution Amplifier, check the cabling to the mains supply and replace the fuse of your power amplifier 710.
Safety instructions regarding mains connection and unplugging the amplifier.
Safety instructions for operating the amplifier in various conditions.
Instructions for unpacking the power amplifier and handling its weight.
Guidance on optimal placement of the amplifier for cooling and stability.
Instructions for connecting cables to the amplifier and system.
Configuration options for display brightness and start-mode.
Procedure for powering on the amplifier and connected devices.
Description of the amplifier's symmetrical dual mono circuit and layout.
Details of the error amp and 'fixed gain'-voltage amp stages.
Information about the power supply unit's components and stability.
Checking delivered items and instructions for storing packing.
Guidance on amplifier placement for connectivity and cooling.
Connecting to mains and audio sources via inputs.
Connecting speakers and remote control via LINK.
Configuration options for Start-Mode, Start-Input, Brightness.
Remote control via RS232 and unit identification.
Using the power button to control ON/OFF states.
Selecting operating modes, inputs, and viewing status/errors.
Soft clip circuit activated for high input levels to protect performance.
Automatic shutdown for output current exceeding 60A.
Automatic shutdown if operating temperature exceeds limits.
Protective fuse for the mains connection against power surges.
Troubleshooting steps for display, music, and error codes.
Procedure for handling errors not covered by specific troubleshooting.
Initial operation period for sonic improvement.
Component care for extended lifetime and standby power consumption.
Instructions for cleaning the amplifier using soft towels.
Technical data for different voltage models including power ratings.
Standby/OFF power consumption and idle consumption figures.
Explanation of OFF, P ON, ON, ERR1-3, LINK, NORM states.
Abbreviations for SYM, XLR female, and ASYM connections.
General| Total Harmonic Distortion (THD) | < 0.001% |
|---|---|
| Input Impedance | 10 kΩ |
| Damping Factor | > 10, 000 |
| Power Consumption (Standby) | < 0.5 W |
| Frequency Response | 0 Hz - 800 kHz |
| Dimensions (W x H x D) | 520 mm |
| THD+N | < 0.001% |
| Inputs | XLR |
To Next Page