Soundcast VG3 - Page 7

Other
Controls
and Features
Volume
Control:
The VG3 volume can
be
adjusted when playing music
or
during speakerphone operation
by
pressing
or
press
and holding
the+
(up)
or-
(down) volume adjustment
buttons on
the
keypad. The
current
volume level will
be
displayed with
blue
LED's on
the
volume
bar
graph.
,...
Mobile devices
that
support
the
AVRCP protocol can
adjust
the
volume
from
the mobile devices
volume slider
control.
Fuel
Gauge:
Press
the
Power button
for
( 1 ) second and beep is
heard
to
display
the
current
battery level
bar
graph us-
ing a combination of RED=Low,
YELLOW=OK,
GREEN=-
Full
LEOs.
The
bar
graph
will
move
counte~lockwise
as
the
battery discharges.
,...
The fuel-gauge and
amber
low battery
LED
indicators
will NOT
be accurate until
at
least
two
full
charging/
discharging cycles have been completed.
Volume
Level
Indication
Blue
LEOs
illuminate
in
clockwise
direction
to
indicate
volume
level.
Volume
down
button
.•
~·<!,·;
'"
~-
+
Volume
up
button
Battery
Status Indication
Yellow
rok
Battery)
Red
[Low
Battery]
Green
[Charged
Battery)
Orange
Power
LED
Keyboard
Lock
The VG3 has two different keypad lockout mechanisms
to
prevent un-intended
or
accidental operation. Both are
disabled
by
default.
When
enabled,
all keypad functions
except
for
power
on/
off
will
be
ignored.
Child
Lock:
To Enable
or
Disable, press and hold
the
mute
button
for
(5) seconds and release. The
top
most
BLUE
LED
will
flash indicating the keypad
is
locked and child lock
is active. Power cycling
the
unit
will
disable
the
keypad
child lock.
Auto
Lock:
To Enable
or
Disable Auto-Lock, press and hold the
mute button
for
( 1
0)
seconds and release. The volume
Keypad Lock
Indicator:
Flashing
Blue:
Child
Lock Active
Flashing Green:
Auto Lock Active
•
•
•
•0
:
<.!)
••
•u
• •
•
• •
+
Mute
button
bar
graph
will
blink twice when enabled and once when
disabled.
When
enabled,
the
keypad
will "Auto-Lock"
after
[3) minutes of no keypad interaction. The top
GREEN
LED
will
blink indicating the keypad is locked The
Auto-Lock
will
remain enabled
or
disabled when power
cycling
the
unit.
Temporarily unlock
the
keypad
for
use while Auto-Lock
is active
by
conducting an
"Unlock Swipe".
This can be
done
by
sliding your finger quickly between
the
power
button and any
other
function button, being sure
to
re-
lease your finger while
it
is
still
over
the
"other
function"
button. The volume
bar
graph will
blink indicating
that
the
keypad is unlocked. Keypad
will
auto-lock
again
after
[3) minutes of no interaction.
7