DAB280 / English Instruction Manual
3
SCAN/SELECT the desired radio station press and hold the corresponding station button
pressed until
"Preset # stored" appears on the display.
RECALL PRESET STATION
1. To recall a stored station, press “PRESET” . “Preset Recall” is shown in the display.
2. Choose with “TUNE +” or “TUNE -” the desired program station number and press to
confirm the “SCAN/SELECT” button.
3. If you choose a preset station number that has not been allocated a station,” Empty” will
displayed.
To call up a direct saved preset station, press the corresponding preset station button on the
device.
DAB INFORMATION
Press “MENU / INFO” repeatedly to cycle through the following information:
DLS (Dynamic label segment), signal strength, genre, ensemble, channel/frequency, signal
error rate, audio bit rate, time, date.
DAB MENU
The device must be in DAB mode. Enter the DAB menu, press and hold the “MENU / INFO”
button. SCAN/SELECT with “TUNE +” or “TUNE -” the one of the following settings and
confirm with “SCAN/SELECT” :
a) Full scan:
Starts the complete station scan. The DAB frequency band is scanned for available stations.
b) Manual tune:
To do so you need to know the station frequency. This can be found on the internet site of
the broadcasting service. SCAN/SELECT individual frequencies and confirm with the
“SCAN/SELECT” button.
c) DRC (Digital Range Control):
The term DRC describes the ratio between the quietest and the loudest sound. If the
dynamic range is very high there are very soft sounds as well as very loud sounds.
Under some circumstances this may present a problem with playback. Let us assume that
you are listening to a radio station in a relatively loud environment. By increasing the volume
you can play the quiet sections louder.
It makes sense here to reduce the dynamic range. SCAN/SELECT between the options:
DRC off: The dynamic range is not reduced.
DRC high: The dynamic range is sharply reduced.
DRC low: The dynamic range is slightly reduced.
d) Prune:
It may be that you can no longer receive some stations after a station scan or change of
location. With this function you can delete these stations from the reception list.
SCAN/SELECT “YES” and confirm with “SCAN/SELECT” .
e) System:
See under “SYSTEM SETTINGS”.
To Next Page
Loading...
