NR976 / English Instruction Manual
5
Programmed Playback
This feature allows you to program 20 CD tracks on a disc for playback in any desired order.
Note: You can program tracks while a disc is stopped.
1.) Press the “PROGRAM” button to enter the Program Mode. The Program
number briefly shows ‘01’, the Program indicator flashes.
2.) Press the “F.SKIP” or “B.SKIP” button to select the first track number you
wish to enter in the program memory. Example: Track Number ‘8’.
3.) When the desired track number appears on the display, press the
“PROGRAM” button again to memorize the track.
4.) Repeat steps 2-3, select a different track number each time until you
have entered up to 20 CD tracks in the program memory.
Note: You may program the same track number to play multiple times in the
program sequence if desired.
5.) Press the “PLAY/PAUSE” button to begin programmed playback. The
“PROGRAM” indicator stops flashing and remains ‘On’. Playback will
begin with the first track you have programmed and will continue until the
last programmed track has been played.
IMPORTANT NOTE
Automatic switch-off: The appliance will switch off about 15 minutes after finishing last playback.
TECHNICAL SPECIFICATIONS
Features and specifications are subject to change without prior notice.
IMPORTER
Technische Änderungen und Druckfehler vorbehalten
Urheberrecht Woerlein GmbH, 90556 Cadolzburg, www.woerlein.com
Vervielfältigung nur mit ausdrücklicher Genehmigung der Woerlein GmbH
To Next Page
Loading...
