SOUNDMASTER SCD1900 - Page 5

SCD1900 / English Instruction Manual
3
Manual Tuning
You can use the manual tuning to tune to weak stations or your desired frequency.
1. During FM operation, repeatedly press the “Tune +” or “Tune –“ button until you read your
desired frequency or the reception is at its best.
2. The stereo icon will be displayed if a FM stereo station is received. To switch between
stereo and mono, press the ■ button.
Programming Preset Stations
You can program stations of your choice and store up to 20 stations into its memories.
1. First tune to your desired station, then press the “Program” button once and the display will
show “P-01” and flash, press the “Preset +” or “Preset –“ button to select the preset
number.
2. When your desired preset number appears on the display, press the “Program” button
again to confirm, the current station will be stored into your desired preset number.
3. Repeat the steps 1 and 2 to program more preset stations, storing a new station into a
preset location will erase the previous stored station in that location.
Recalling the Stored Preset Stations
To recall the stored preset stations, repeatedly press the “Preset +” or “Preset –“ button until
you see your desired preset number, the associated frequency will be displayed.
CD
NOTE: Although this CD/MP3 player can read CD-R and CD-RW discs in addition to normal
CDs, the playability of CD-R and CD-RW discs may be affected by the type of software that was
used to create the discs, as well as the quality and condition of the blank media you are using,
100% playability cannot be guaranteed. This is not an indication of a problem with the player.
Playing the CD
1. To select CD mode, repeatedly press the “Mode” button until “CD” is displayed.
2. Open the CD door and load the disc with the printed label side facing up and close the CD
door. The display will finally show the total number of tracks. If a CD/MP3 disc is being
played, the display will show “MP3”.
3. Press the ▶II button to start playback from the beginning, and you can now press the ▶II
button to toggle select between the playback “PAUSE” and “PLAY” function.
4. To skip forward or back to other tracks during playback, press the ◀◀ or ▶▶ button.
5. To select other folders in the CD/MP3 disc, press the “Preset +” or “Preset –“ button.
6. To stop playback, press the ■ button.
Repeat and Random Play
During playback, you can press the “Repeat” button to select the repeat and random playback
function:
1. To repeat the same track, press “Repeat” button once, the display will show “Repeat One
icon”.
2. To repeat the entire disc, press the “Repeat” button again, the display will show “Repeat All
icon”.
3. If you are playing a MP3 disc, an additional “FOLDER” option will appear. This will repeat
the current folder.