SCD2000 / English Instruction Manual
LOCATION OF CONTROLS
1 SKIP DOWN Button 11 FUCNTION Switch
2 RANDOM Button 12 Aux-In Jack
3 PROGRAM Button 13 Antenna
4 PLAY/PAUSE Button 14 Handle
5 SKIP UP Button 15 Battery Compartment
6 STOP Button 16 CD Compartment
7 REPEAT Button 17 LED Display
8 TUNING Control 18 AC Socket
9 AM/FM Button
10 VOLUME Control
EN 1
AC Operation
Before operation, please make sure that the VOLTAGE mentioned on the unit is same as the
voltage of your local area. Unravel the AC power cord, insert one end into the AC socket on the set,
and the other end into a standard AC outlet.
Attention
1. Do not plug or unplug the power cable while you have wet hands.
2. When planning not to use this unit for a long time, disconnect the power cable from the wall
outlet.
3. When disconnecting the power cord from the wall outlet, do not pull on the cord in order to
avoid shock risks caused by damaged cable.
Battery Operation
Disconnect the AC cord set completely. Open the battery compartment door and insert 6 pieces
UM-2 "C" size batteries into the battery compartment with battery polarity as shown inside the
battery compartment.
Radio Operation
1. Set the FUNCTION switch to RADIO position.
2. Set the AM/FM Button to select AM / FM radio
3. Rotate the TUNING control to tune to your desired radio station.
4. Adjust the sound level by rotating the VOLUME control.
5. To turn off the radio, set the FUNCTION switch to OFF position.
ANTENNA
For best reception, fully extend the FM Antenna to receive FM stations.
EN 2
To Next Page