Soundoff Signal 380 SERIES - Page 2

ETSA380R 4.12
380 SERIES REMOTE SIREN
ETSA380R
PARK KILL WILL DEACTIVATE SIREN
-AUX AND HORN RING WILL NOT REACTIVATE
ONLY YELP, WAIL OR TONE BUTTONS WILL REACTIVATE
**Relay 'X' is the relay associated with the
pushbutton programmed for arrow control. (ie.
Button 1 is set up for Arrow control, then Relay 1 is
Relay 'X')
FUNCTION **RELAY
‘X’
RELAY #9
OFF
OFF OFF
LEFT ARROW
ON OFF
RIGHT ARROW
OFF ON
CENTER OUT ARROW
ON ON
+10-30V - Push Button #1 Output
+10-30V - Push Button #2 Output
+10-30V - Push Button #3 Output
+10-30V - Push Button #4 Output
Push Button #7 Normally Closed Output
Push Button #8 Normally Open Output
Push Button #7 Normally Open Output
BLUE
BROWN
YELLOW
ORANGE
RED/WHITE
GREEN/BLACK
RED/BLACK
WHITE
VIOLET
GREY
RED
GREEN
BLACK
GREEN/WHITE
+10-30V - Push Button #5 Output
+10-30V - Push Button #6 Output
+10-30V - Relay #9 Output for 2 wire Arrow Control Interface
Push Button #7 Input
Push Button #8 Input
Push Button #8 Normally Closed Output
+10-30V
50A
Fuse
+10-30V Level 3 Output
+10-30V
Level 2 Output
+10-30V Level 1 Output
+10-30V
50A
Fuse
YELLOW
GREEN
BLUE
RED RED
Cable to control panel
4” RJ-45 Jumper
Cable
+10-30V
+10-30V
RADIO
REBROADCAST
BLUE
BLUE
PARK KILL
YELLOW
BLACK
RED
15 amp
Fuse
15 amp
Fuse
+10-30V
IGNITION
ORANGE/BLACK
Backlight
Horn Ring Out
(WHITE)
Horn Ring In
(WHITE/BLACK)
+10-30V
VIOLET
GRAY
Auxiliary
NEUTRAL SAFETY SWITCH
RADIO REBROADCAST
OUPUT LEVEL ADJUST
3 amp
Fuse
ORANGE/BLACK ORANGE
11 Ohm Speaker
100 Watt
GREEN/BLACK
GREEN
11 Ohm Speaker
100 Watt
PSRNFLT1*
*IMPORTANT NOTE:
In-line filter (PSRNFLT1) must
be installed to protect amplifier
and speakers from damage.
Note: All fuses shown are user
supplied & must be installed to
ensure safe operation
MUST BE CONNECTED TO
SAME SOURCE CONSTANT,
TIMED OR IGNITION
NOTICE:
When an output is connected to a device which is
required to function only when ignition switch is ON,
a relay needs to be installed in-line with the siren switch
output to ensure an operator can’t activate the device
without the ignition switch ON.
See wiring diagram details: