1.800.338.7337 / www.soundoffsignal.com
6
4" & 3" MPOWER
®
FASCIA LIGHTS
ENGLISH 0000JL 1123 REV C
4" & 3" MPOWER
®
FASCIA LIGHTS
MULTI-MOUNT INSTALLATION:
Multi-Mount Bracket (FIG. 1) P/N: PMP2BKDGAJ
1. Pre-drill mount holes as required (bracket holes and
spacing are indicated on page 7 (4") or page 8 (3").
2. Place bracket onto desired vehicle’s surface and secure
with screws (not provided).
3. Install Heat Sink onto “mPOWER Stud Mount, Threaded”
light as indicated. Wire passes through center hole.
4. Install “mPOWER Stud Mount, Thread” light onto bracket
as indicated. Wire passes though rear relief.
5. Install 2 lock nuts onto “mPOWER Stuf Mount, Thread”
light as indicated. Hand tighten until final adjustment.
6. Adjust angle of light to desired direction and tighten 2
lock nuts until secure. After the nut makes full contact
with the mounting surface, hand tighten 1/8th turn
(torque no more than 15 in-lbs.)
7. Make wire connections.
GRILLE MOUNT BACKPLATE INSTALLATION:
Grille Mount Backplate (FIG. 2) P/N: PMP2BKGBPB
1. Pre-drill mount holes as required (bracket holes and
spacing are indicated on page 7 (4") or page 8 (3").
2. Place bracket onto desired vehicle’s surface and secure
with screws (not provided).
3. Install Heat Sink onto “mPOWER Stud Mount” light as
indicated. Wire passes through center hole.
4. Install “mPOWER Stud Mount” light onto bracket as
indicated. Wire passes though rear relief.
5. Install 2 lock nuts onto “mPOWER Stud Mount” light as
indicated. Hand tighten until final adjustment.
6. Adjust angle of light to desired direction and tighten 2
lock nuts until secure. After the nut makes full contact
with the mounting surface, hand tighten 1/8th turn
(torque no more than 15 in-lbs.)
7. Make wire connections.
FIG. 1FIG. 1
MULTI-MOUNT
WIRE HOLE
THREADED STUD x2
MOUNT SURFACE
FIG. 2FIG. 2
*FOR USE WITH STUF MOUNT MPOWERS ONLY
GRILLE MOUNT BRACKET
90°±15° EDGE MOUNT BRACKET
STUD MOUNT - THREADED LIGHT
HEAT SINK
LOCKNUT X 2
THREADED STUD X 2
DO NOT USE POWER
TOOLS TO TIGHTEN
DO NOT USE POWER
TOOLS TO TIGHTEN