- 6 -
SPECIFICATIONS
Maximum Input Level
Maximum Output Level
Frequency Response
Total Harmonic Distortion
Signal to Noise Ratio
Balanced Input Noise Rejection
Input Impedance
Output Impedance
Power Supply
Power draw
Recommend fuse rating
15 V rms
13.5V peak
10Hz - 100KHz ; +/-1dB
0.003%
-130dB
>60dB
10 Kohm
150 Ohms
High headroom PWM
150mA
1 Amp
The bass response in a system is affected by four factors:
(1) The acoustics of the vehicle
(2) The locations of the speakers
(3)The music on the tape
(4) Speakers and speaker enclosures.
Because of the variations in the recording process, we developed BX-12 to help restore
any low frequencies lost during the recording process, however, the acoustics of various
environments are different.
The Sweep control allows you to select a center frequency ( the frequency most affected)
between 27 and 63 Hz. The Width control then allows you to control the shape of the filter
centered around the Sweep frequency.
The BX-12 is the most powerful bass component. This device equipped with several
different Bass Output selections. If you should need to change the settings, Please use
the chart below for guidance. It is recommended : listen to the factory setting before
changing your Bass Output settings.
SETTING THE BASS OUTPUT CONTROL
Recommended Settings
Setting
2.5Volt
5Volt
7.5Volt
10Volt
Amplifier Input Voltage
3Volt or less
5Volt or less
7.5Volt or less
Oh My Gosh !!!!!!!!!!!!!!!!!
Minimum Speaker Size
8
10
12
ADJUSTING THE PARA-BASS CONTROLS
To Next Page
Loading...
