Why won't my Soundstream Monitor turn on?
If your Soundstream Monitor isn't powering on and no sound is produced, the fuse may be blown. Replace it with a fuse of the same amperage. If it blows again, consult your store of purchase. Alternatively, the wiring may be incorrect, in which case you should consult your local retailer.
What to do if buttons aren't working on my Soundstream Monitor?
If nothing happens when you press the buttons and the display of your Soundstream Monitor is not accurate, the microprocessor may have malfunctioned due to noise. Turn off the power, then press the [no open] button and remove the DCP. Press the reset button for about 2 seconds with a thin rod. Alternatively, the panel or main unit connectors may be dirty. Wipe the dirt off with a soft cloth moistened with cleaning alcohol.
How to fix no sound with amplifier/antenna on Soundstream VR-103?
If there's no sound output from your Soundstream Monitor when amplifiers or a power antenna are attached, the power antenna lead may be shorted to ground, requiring excessive current, or there may be an issue with the remote on the amplifiers or power antenna. To resolve this: 1. Turn off the unit. 2. Remove all wires attached to the power antenna lead and check each wire for a possible short to ground using an ohm meter. 3. Turn the unit back on. 4. Reconnect each amplifier remote wire to the power antenna lead one by one. If the amplifiers turn off before all wires are attached, use an external relay to provide remote-on voltage (excessive current required).
Why is the sound bad on my Soundstream VR-103 after turning it on?
If the sound quality of your Soundstream Monitor is poor immediately after turning it on, the compact disc might be dirty. Clean the compact disc without causing scratches. Alternatively, the compact disc may be heavily scratched or warped; replace it with a compact disc without scratches.
What to do if Soundstream Monitor sound is bad after turning on?
If the sound is bad on your Soundstream Monitor right after you turn it on, water droplets may have formed on the internal lens if the car was parked in a humid place. Let the unit dry for about 1 hour with the power on.
General| Brand | Soundstream |
|---|---|
| Model | VR-103 |
| Category | Monitor |
| Language | English |
To Next Page
