Southwire 31011F - IR Thermometer Operation; Battery Replacement

NOTE:IR Thermometer Operation
87
/VSK[OL[OLYTVTL[LYI`[OLOHUKSLHUKWVPU[P[[V^HYKZ
the desired surface to be measured.
2. Press and hold the trigger to turn the IR thermometer on.
The red laser dot indicates the center of the circular measure-
ment area. Aim the laser at the surface you wish to measure.
The LCD display will display the temperature of the surface.
As long as you press and hold the trigger, the IR thermometer
will continue to gather temperature data and display it on the
LCD screen. It may take a few seconds to get a stable
reading.
3. Release the trigger. When you release the trigger, the IR
thermometer will stop gathering temperature data but will
continue to display the last temperature the thermometer
measured.
To conserve batteries, the meter will turn off 15 seconds after
the trigger is released.
NOTE:
࠮-VYNYLH[LYHJJ\YHJ`LUZ\YL[OH[[OLZ\YMHJL`V\^PZO[V
measure is larger than the spot size measured by the meter.
Reference the spot diagram above or printed on the side of
the meter.
࠮0M[OLZ\YMHJLPZOPNOS`YLMSLJ[P]LHWWS`LSLJ[YPJHS[HWLVYMSH[
black paint to the surface before attempting to take measure-
ments. Allow time for the tape or paint to reach the same
temperature as the surface.
࠮;OLTL[LYJHUUV[TLHZ\YL[OYV\NO[YHUZWHYLU[Z\YMHJLZ
such as glass. It will measure the surface temperature of the
glass instead.
࠮:[LHTK\Z[ZTVRLL[JJHUPU[LYMLYL^P[O09[OLYTVTL[LY
measurements.
࠮4HRLZ\YL[OLZ\YMHJLILPUNTLHZ\YLKPZJSLHUHUKMYLLVM
frost, dirt, oil, etc.
࠮;OLTL[LYH\[VTH[PJHSS`JVYYLJ[ZMVYJOHUNLZPUHTIPLU[
[LTWLYH[\YL/V^L]LYP[JHU[HRL\W[VTPU\[LZ[VHKQ\Z[
to wide variations.
Battery Replacement
;OL3*+^PSSKPZWSH`[OLSV^IH[[LY`Z`TIVS^OLUP[»Z
time to replace the batteries.
6WLU[OLIH[[LY`JVTWHY[TLU[JV]LY9LTV]LHUK
properly discard the old batteries. Replace with new AAA
batteries and close the battery compartment cover securely.