The SOVEREIGN 18V Cordless Hedge Trimmer (Article No. 555375, Model No. ASYEHT01450) is a battery-operated tool designed for easy gardening, specifically for trimming hedges, bushes, and shrubs. It is intended for private domestic use and should not be used for commercial trade or purposes other than those described in the manual.
Safety Warnings and Symbols:
The manual emphasizes reading all safety warnings and instructions before assembly and operation to prevent electric shock, fire, and serious injury. Key safety symbols include:
- Warning! (exclamation mark in a triangle)
- CE Mark: Conforms to all relevant safety standards.
- UKCA Mark: Product complies with applicable UK Directives.
- Read the instruction manual before use.
- Wear ear protection.
- Wear eye protection.
- Wear dust mask.
- Keep fingers away from moving cutting device!
- Disconnect the battery pack before any adjustment or maintenance.
- Do not expose to rain.
- Guaranteed sound power level data (94dB), in accordance with Directive 2000/14/EC.
Charger Specific Symbols:
- Before use, carefully read through the user manual.
- For indoor use only.
- Class II equipment.
- Pole orientation.
- Waste electrical products should not be disposed of with household waste. Recycle where facilities exist.
Battery Specific Symbols:
- Anode (+)
- Cathode (-)
- Do not dispose of batteries in rivers or immerse in water.
- Do not subject the battery to strong sunlight over long periods or leave on a heater (max. 45°C).
- Do not dispose of batteries in a fire. They will explode and cause injury.
- Contains Li-ion battery. All batteries must be recycled or disposed of properly.
General Safety Guidelines:
- Work Area Safety: Keep the work area clean, well-lit, and free from children and bystanders. Do not operate in explosive atmospheres.
- Personal Safety: Stay alert, use common sense, and avoid operating while tired or under the influence. Always wear personal protective equipment, including eye protection, dust mask, non-skid safety shoes, hard hat, or hearing protection. Prevent unintentional starting by ensuring the switch is off before handling the tool. Maintain proper footing and balance, and dress properly, avoiding loose clothing or jewelry that could get caught in moving parts.
- Power Tool Use and Care: Use the correct power tool for the application. Do not use if the switch does not turn it on and off. Remove the battery pack before making adjustments, changing accessories, or storing. Store idle power tools out of reach of children and untrained users. Maintain tools, check for misalignment or breakage, and keep cutting tools sharp and clean. Use the power tool, accessories, and tool bits in accordance with instructions and working conditions.
- Recharging: Only recharge with the charger specified by the manufacturer. Using other chargers may create a fire risk.
- Battery Packs: Use only specifically designated battery packs. Keep battery packs away from other metal objects when not in use to prevent short-circuiting.
- Battery Leakage: In abusive conditions, liquid may be ejected from the battery. Avoid contact. If contact occurs, flush with water and seek medical help if it contacts eyes. The battery fluid (25-30% potassium hydroxide solution) can be harmful; rinse skin with water and neutralize with mild acid, or rinse eyes with clean water for at least 10 minutes and consult a physician.
- Short-circuiting: Do not short-circuit battery packs or store them haphazardly with conductive materials.
- Disposal: Lithium-ion batteries should not be disposed of in household waste, fire, or water. They must be collected, recycled, or disposed of in an environmentally-friendly manner.
Charger Safety Instructions:
- Read all instructions and cautionary markings on the charger before use.
- The charger and battery pack are specifically designed to work together; use only the supplied charger with the battery pack for this tool.
- Charge the battery pack indoors only.
- Do not charge non-rechargeable batteries.
- Protect the charger from moisture and wet conditions.
- Avoid placing objects on top of the charger or near heat sources to prevent overheating.
- Do not use an extension cord unless absolutely necessary.
- Do not use a damaged charger; have it checked and repaired by an authorized service center.
- Charge batteries in a well-ventilated area, away from flammable materials. Do not overcharge or leave unattended during charging.
Hedge Trimmer Specific Safety:
- Keep all body parts away from the cutter blade.
- Do not remove cut material or hold material when blades are moving.
- Ensure the switch is off when clearing jammed material.
- Carry the hedge trimmer by the handle with the cutter blade stopped. Always fit the cutting device cover when transporting or storing.
- Hold the power tool by insulated gripping surfaces only, as the cutter blade may contact hidden wiring.
- Check the hedge for foreign objects (e.g., wire fences).
- Use both hands when operating the hedge trimmer.
Product Description and Parts:
The hedge trimmer consists of:
- Blade
- Guard
- Safety switch
- Trigger
- Battery pack (Model ZDBP18012001)
- Charger (Model XZ2200-0500WB)
- Charging plug
- Front handle
- Blade sheath
Assembly and Charging:
- Charging the Battery: The battery needs to be charged before first use and whenever power is insufficient. The charger and battery pack are specifically designed to work together. Never insert metallic objects into connections.
- Plug the charger into an AC power outlet.
- Insert the charger plug (7) into the charging hole (A1) on the battery pack (5).
- The LED (A2) lights on the battery pack will flash, indicating charging.
- A full charge takes 4-5 hours, and the three LED (A2) lights will turn green.
- Optimal charging temperature is 18-24°C. Allow hot battery packs to cool for 30 minutes before recharging.
- The charger and battery pack may become warm during charging, which is normal.
- Do not cover the charger or charge in direct sunlight/near heat sources.
- If the battery pack does not charge properly, check the main socket and ensure the temperature is within the optimal range. If problems persist, contact a service center.
- Recharge when power is insufficient; do not continue using.
- Unplug the charger from the power supply when not in use or before cleaning.
- Do not immerse the charger in water or any other liquid.
- Never attempt to open the battery pack.
- Installing/Removing Battery Pack:
- Always release the on/off trigger before insertion or removal.
- To remove, depress the button (D) on both sides of the battery pack and pull the pack (E) out.
- To install, align the ribs on the battery pack with the slots in the housing and push until it locks with a click.
Operating the Hedge Trimmer:
- Starting: The tool is equipped with a dual safety-switch system. Hold the product with one hand at the rear handle and the other at the front handle. Press the trigger (F) and the front handle safety switch (G) simultaneously to switch the product on.
- Switching Off: Release either the front handle safety switch (G) or the trigger (F).
- Blade Sheath: Remove the blade sheath before use. Ensure the battery pack is removed from the trimmer before handling the blade sheath.
- Cutting Guide:
- Wear eye protection and appropriate clothing.
- Hold the front handle with one hand and the rear handle with the other.
- Tilt the blade towards the hedge and trim from the bottom upwards.
- Trim the sides first, then the top.
- For very long branches, cut in several stages.
- Ensure no hard objects (e.g., railings) are in the hedge.
- If the blade jams, switch off and remove the battery pack before clearing the obstruction.
- Do not force the trimmer to cut oversized branches; use secateurs or shears for these.
- Evergreen hedges and shrubs should be trimmed in April and August. Conifers and fast-growing shrubs can be trimmed every six weeks during the growing season.
Maintenance and Storage:
- General Maintenance: Always remove the battery pack before any repair work.
- Keep all nuts, bolts, and screws tight.
- Examine and replace worn or damaged parts.
- Check that guards are undamaged and correctly fitted.
- Do not use if blades are blunt or worn, as this overstresses the motor and gearbox.
- Cleaning the Product:
- Use a soft brush to remove dust.
- Wear safety glasses.
- Wipe the product enclosure with a slightly damp cloth.
- Do not spray with water.
- Blade Maintenance:
- Wear gloves when handling or cleaning the blade.
- Clean the cutting blade after operation and lubricate with protective spray. Lubricate periodically during longer cutting jobs.
- Visually check cutting edges and blade bolt tightness.
- Ensure the blade is covered with the supplied blade protection.
- Storage and Transport:
- Clean the unit thoroughly.
- Store in a safe, dry room, allowing the motor to cool down.
- Store out of reach of children.
- Use original packaging whenever possible.
Troubleshooting:
The manual provides a troubleshooting table for common issues:
- Product does not start:
- Possible cause: Not connected to battery pack. Solution: Connect to battery pack.
- Possible cause: Low battery capacity. Solution: Charge the battery pack.
- Possible cause: Other defect. Solution: Check with a specialist.
- Product does not reach full power:
- Possible cause: Low battery capacity. Solution: Charge the battery pack.
- Possible cause: Air vents are blocked. Solution: Clean the air vents.
- Does not cut:
- Possible cause: Cutting device worn. Solution: Have a specialist replace it.
If a fault is suspected, return the trimmer to an authorized service center for repair.
Technical Data:
- Model no.: ASYEHT01450
- Voltage: 18V d.c.
- Battery type: Lithium-ion
- No load speed: 1400/min
- Cutting length/tooth gap: 405mm/14mm
- Battery pack model: ZDBP18012001
- Battery capacity: 2.0Ah
- Charging time: Approx. 4 hours
- Charger model: XZ2200-0500WB
- Input voltage of charger: 100-240VAC 50/60Hz
- Input current of charger: 0.3A
- Output voltage of charger: 22V d.c.
- Output current of charger: 0.5A
- Charger protection class: / II
- Noise data:
- A-weighted sound pressure: 73.5dB(A) KPA: 3dB(A)
- A-weighted sound power: 88.9dB(A) KWA: 3dB(A)
- Guaranteed sound power level: 94dB(A)
- Wear ear protection (PPE).
- Vibration data:
- Typical weighted vibration: 1.395m/s² K=1.5m/s²
Customer Support and Warranty:
- Technical Support: UK-based customer helpline (01904 727509, Mon-Fri 9am-5pm, Sat-Sun 11am-4pm) and email (support@coreservice.co.uk).
- Online Resources: Assembly, starting, and maintenance videos, and ordering spares available at www.coreservice.co.uk.
- Warranty: The product is covered by a 1-year warranty for manufacturing defects in materials, workmanship, and finish. Claims must be made within 1 year of purchase at a Homebase store with proof of purchase. The warranty offers free repair, replacement, or refund. It does not apply to misused, neglected, or commercially used products.
To Next Page
General
