– 17 –
Inverter Air-to-Water Heat Pump
Press‘Clock’ button to enterthe system clocksetting interfaceasbelow.
Settingtime
Press up key
andincrease
value
Pressdown
keyand
decrease value
Cancel and
return to
previous
interface
Save and
back to
setting
interface
Return
Running Mode
Press the running mode button in the setting interface to check the current operation mode and the main temperature status as
shown below.
Clock Setting Display
1. Press the corresponding up and down button of ‘Month’ to adjust the month setting, the setting range is mark with abbreviated
month names from January to December. Long press this button to continuous adjust the setting.
2. Press the corresponding up and down arrow button of ‘Day’ to adjust the day setting. The setting range is from 1 to 31. Long
press this button to continuously adjust the setting
3. Press the corresponding up and down arrow button of ‘Year’ to adjust the year setting. The setting range is from 2000 to 2100.
Long press this button to continuously adjust the setting.
4. Press the corresponding up and down arrow button of ‘Hour’ to adjust the hour setting. The setting range is from 0 to 23. Long
press this button to continuously adjust the setting.
5. Press the corresponding up and down arrow button of ‘Minute’ to adjust the minute setting. The setting range is from 0 to 59.
Long press this button to continuously adjust the setting.
6. Press the ‘Enter’ button, the system clock will change according to your setting. If the setting is not correct, the system will
automatically calibrated.
7. Press the ‘Cancel’ button to cancel the current setting and return to the setting interface.
8. If H03 is shown in degree Fahrenheit, the operation method and display are as the clause (1) - (7) mentioned above. When it is
shown in degree centigrade, the clock setting format is as below.
Heat ing
113° F
113° F
113° F
51°F
To Next Page
Loading...
