EasyManua.ls Logo

SPANARCI SANDY 2000 - Inflation Speed Issues; Inflation Not Starting; Preset Pressure Adjustment Issues; Zero Pressure Display

SPANARCI SANDY 2000
27 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Problem
Slow inflation speed
Solution
1. Check whether the air compressor's battery level is sufficient.
2. Check whether the air hose is leaking.
3. Check whether both ends of the air hose are securely connected.
4. Check whether the item that is being inflated is leaking
Air compressor turns on
but does not inflate
1. Check whether the air compressor's battery level is sufficient.
2. Check whether the pressure of the item being inflated exceeds the preset pressure.
Unable to increase or decrease
the preset pressure
Make sure the air compressor is set to the correct mode.
Manual mode has a blank display without any icons and allows you to adjust the preset value within the
range of 3 - 150 psi.
- 20 -
The inflator inflates normally but
the displayed pressure is zero
The pressure of low-pressure inflatables including balloons is too low to be measured.