EasyManua.ls Logo

Spark Bikes Spark X - Battery Management; Battery Care and Storage; Battery Installation and Removal

Default Icon
22 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Battery charge
Ensure that your battery is fully charged before your first ride. The charging port is
located on the battery. Lift the rubber seal to charge the battery
Battery care
Keep the battery indoors during extreme weather
Avoid storing the battery in high temperature or humid areas
Remove the battery from the bike when storing for more than two weeks. Ensure the
battery is charged at least 50% prior to storing
Charge around 70% if you plan to store your battery for few months. The battery will
slowly discharge over time. When the power level goes below 20% charge it up again
around 70%
To clean the battery and the battery housing, use a dry rag, and if necessary slightly
damp rag. Do not spray with water, it may damage the battery or cause a short circuiting
Charge the battery with the supplied charger. Do not attempt to use other chargers as it
may damage the battery or risk a fire or an explosion. Ensure that you charge your
battery on a non-inflammable surface. It is recommended that you charge your battery
in an area with smoke/fire detector in place
Do not charge the battery in a wet and humid place or when exposed to strong sun light
Battery installation and removal
Steps:
Insert the key into the battery keyway, turn the key clock wise, lift the battery lever, and
pull the battery out of its holder
!
Page 13