Temperature Sensor
f5
f7f6
Component:
Image Reference:
j5
Jumper Wire
j7
Jumper Wire
Jumper Wire
GND
Jumper Wire
5V
5V
+
Jumper Wire
A0
j6
+
is circuit uses the Arduino IDE's serial monitor. To open this, rst upload the
program then click the button which looks like a magnifying glass in a square. In
order for the serial monitor to operate correctly it must be set to the same baud
rate (speed in bits per second) as the code you're running. is code runs at 9600
baud; if the baud rate setting is not 9600, change it to 9600.
Opening your serial monitor:
1
2
3
+V
SIGNAL
GND
- +V
OUT
Page 47
To Next Page
Loading...