Once the board is in the socket, gently hold the MicroMod Processor Board down and tighten the screw with a
Phillip's head.
Once the board is secure, your assembled MicroMod system should look similar to the image below!
Connecting Everything Up
With your processor inserted and secured it's time to connect your carrier board to your computer using the USB-C
connector on the Carrier. Depending on which carrier you choose and which drivers you already have installed,
you may need to install drivers.
Note: If you've never connected a CP2104 device to your computer before, you may need to install drivers
for the USB-to-serial converter. Check out our section on How to Install CP2104 Drivers for help with the
installation.
To Next Page
Loading...
