Why does wood burn so fast in my Spartherm Varia M60h Indoor Fireplace?
If the wood in your Spartherm Indoor Fireplace is burning too fast, it might be because the air control needs adjustment. Try adjusting the air control down. Also, check that the ash plug is properly seated (if your appliance has one), inspect the door gasket to ensure it's sealing well, and consider that the wood might be extremely dry.
Why isn't my Spartherm Varia M60h burning hot enough?
If your Spartherm Indoor Fireplace isn't burning hot enough, it could be due to a few reasons. The wood might be too wet, in which case you should use dry wood. You might also have insufficient draft, consider adding more pipe. Also, ensure that the air control is fully open and that the air opening is not obstructed.
What to do if Spartherm Varia M60h Indoor Fireplace smokes when the door is open?
If your Spartherm Indoor Fireplace smokes when the door is opened, consider these possible solutions: * Address potential cold air blockage by burning a piece of paper to establish a draft. * Increase draft by adding more pipe. * Allow the air to stabilize before opening the door. * Make sure the baffles are correctly positioned. * If negative pressure is the issue, open a window near the appliance.
Why does my new Spartherm Indoor Fireplace emit an odor?
If your Spartherm Indoor Fireplace is emitting an odor, it could be due to the paint curing. Please refer to the “GENERAL INSTRUCTIONS” section for more information.
General| Model | Varia M60h |
|---|---|
| Category | Indoor Fireplace |
| Width | 600 mm |
| Material | Steel |
| Fuel Type | Wood |
| Energy efficiency class | A |
| Minimum chimney draft | 12 Pa |
| Combustion air connection | 125 mm |
| External air connection | Yes |
| Flue Diameter | 150 mm |
| Efficiency | 80% |
To Next Page
