Spear & Jackson S2655HP

Questions and Answers

M
marymcknightAug 9, 2025
What to do if my Spear & Jackson S2655HP Trimmer engine does not start?
- M
  michael34Aug 9, 2025
  If your Spear & Jackson Trimmer's engine won't start, several factors could be the cause. First, ensure there's enough petrol in the fuel tank; if not, add petrol. If starting from cold, make sure you've pressed the primer. If starting warm, the primer should not be pressed, and you may need to dry the spark plug. Also, check the spark plug itself: dry it if wet, replace it if damaged, and ensure its connector is properly attached. Verify that the ignition switch is set to “I,” and confirm the choke lever position is correct as per the starting steps.
L
linda30Aug 17, 2025
Why does my Spear & Jackson S2655HP Trimmer engine keep stopping?
- R
  Richard MillerAug 17, 2025
  Your Spear & Jackson Trimmer engine might stop for several reasons. Ensure there is enough petrol in the fuel tank by adding petrol. Check for any blockages in the cutting device and remove them. If the machine is cold, allow the engine to warm up at idle for a while. Also, verify that there is enough of the correct 4-stroke engine oil, adding more to reach the full level if needed.
I
idelgadoAug 25, 2025
Why is my Spear & Jackson S2655HP Trimmer vibrating excessively, making noise, or emitting too much exhaust?
- R
  Ryan AndersonAug 25, 2025
  Excessive vibration, noise, or exhaust from your Spear & Jackson Trimmer can stem from a few issues. A dull or damaged cutting device could be the culprit, in which case you should replace it with a new one. Check if any bolts or nuts are loose and tighten them. Also, ensure you're using the correct petrol/oil mixture; if not, empty the incorrect fuel and refill with the right one.
O
ograntSep 1, 2025
How to improve unsatisfactory cutting performance of Spear & Jackson S2655HP?
- J
  John LyonsSep 1, 2025
  If your Spear & Jackson Trimmer isn't cutting well, consider these points: * Check if the cutting blade is dull or damaged. If so, have a specialist sharpen or replace it. * Ensure that you are only cutting materials that are within the product's capacity.

Summary

SAFETY INFORMATION

General safety warnings

Provides essential safety instructions to prevent injury and ensure safe operation of the hedge trimmer.

Work area safety

Guidelines for maintaining a safe work environment, free from hazards and distractions.

Personal Safety

Advice on personal protective equipment and maintaining awareness to prevent injury.

Operating safety

Rules for safe operation, including proper handling and awareness of surroundings.

PREPARE

Add engine lubricant Oil: Initial use

Step-by-step guide to adding engine lubricant oil to the hedge trimmer before its first use.

Fueling

Instructions on how to safely refuel the hedge trimmer with unleaded gasoline.

OPERATE

Hold the machine

Proper technique for holding the hedge trimmer securely during operation for stability.

Squeeze throttle to start cutting

Procedure for engaging the throttle to begin the cutting process.

Cutting work

Techniques for performing cutting tasks, including posture and motion.

MAINTENANCE

Warning! Always switch off the engine and wait for cooling down of engine.

Critical safety warning before performing any maintenance tasks.

Inspection and maintenance item and interval by operator

Overview of maintenance tasks and their recommended frequency for the operator.

Check engine lubricant level before each use

Change engine lubricant oil

Check hand guard

Inspect the Spark Plug

TROUBLESHOOTING

Engine does not start

Common causes and solutions for the engine failing to start.

Engine stops

Identifies issues and fixes when the engine unexpectedly stops during use.

Unsatisfactory cutting performance

Excessive vibration; noise or exhaust