EasyManua.ls Logo

Speck pumps A91-II VSP - User Manual

Default Icon
28 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Installation, Operation, and Service Manual
1.1 THP Dual Voltage Series
Variable Speed Pool Pump
Motor Version 2.0
02/2019

Table of Contents

Questions and Answers

  • J
    Joshua PattonAug 9, 2025
    What to do if my Speck pumps Water Pump will not prime?
    • A
      Adam PerryAug 9, 2025
      If your Speck pumps Water Pump won't prime, it could be due to several reasons. First, check for suction air leaks by ensuring the see-through lid and o-rings are clean and correctly placed, and hand-tighten the lid. Also, tighten all pipes and fittings on the suction side. Ensure the water level in your pool is high enough for flow through the skimmer and that the strainer tank is full. Open all valves, clean the skimmer and strainer tank, and inspect the pump for impeller clogging. Finally, check the motor voltage; if it's too low, the pump won't run.
  • G
    George DouglasAug 19, 2025
    Why my Speck pumps Water Pump motor does not turn on?
    • S
      Stephanie LeeSep 12, 2025
      If the motor of your Speck pumps Water Pump isn't turning, it could be due to a lack of power or a jammed pump. Ensure all power switches are on and the fuse or circuit breaker is properly set. Check the timer setting. Inspect the motor wiring at the terminal. With the power off, try turning the shaft; if it doesn't spin freely, the pump may need disassembly and repair.
  • L
    Lori ColemanAug 29, 2025
    How to fix low flow in Speck pumps A91-II VSP?
    • M
      michellenewtonAug 30, 2025
      Low flow in your Speck pumps Water Pump can be caused by a dirty filter or a suction leak. Backwash the filter when the filter pressure is high, or clean the cartridges. Also, check for suction leaks.

Summary

Important Safety Instructions

Installation Information

Electrical Installation

Details on securely grounding the pump motor and selecting appropriate wire sizes.

Operation

Start-Up guide

Steps for initial pump startup, including priming, setting the schedule, and basic operation.

Enter Programming Mode

Instructions on how to access the pump's programming menus for settings adjustments.

Schedule (SCHE) Menu

How to set and adjust power levels and durations for the pump's 24-hour cycle.

Normal Operation

Describes how the pump runs through its programmed schedule and transitions between settings.

Service and Maintenance

Troubleshooting

Controller Errors

List of error codes displayed by the controller and their corresponding descriptions and solutions.

General Pump Troubleshooting

Common pump problems like not priming or low flow, with possible causes and solutions.

Blocked Impeller

Removal and Replacement of the Impeller and;or Mechanical Seal

Motor Replacement

Speck pumps A91-II VSP Specifications

General IconGeneral
BrandSpeck pumps
ModelA91-II VSP
CategoryWater Pump
LanguageEnglish

Related product manuals