What to do if my Speck Swimming Pool Pump motor does not turn on?
If the motor of your Speck Swimming Pool Pump isn't turning, start by verifying that all power switches are on and that the fuse or circuit breaker in the power box is properly set. Also, with the power off, try to turn the shaft. If it doesn't spin freely, it may be jammed and require repair by an authorized repairer.
Why is the flow low in my Speck Swimming Pool Pump?
Low flow in your Speck Swimming Pool Pump could be due to a dirty filter. Backwash the filter or clean the cartridges. Another potential cause is a suction leak. Refer to the troubleshooting steps for 'Pump will not prime' to address suction leaks.
Critical safety warnings and procedures to follow for pump operation and maintenance.
Guidelines for choosing a suitable location for pump installation.
Instructions for connecting the pump's piping and fittings correctly.
Details on how to connect the pump to the electrical power supply safely.
Step-by-step guide for starting the pool pump for the first time.
Operation details for the Speck 90/500 DS dual speed pump model.
Procedures for regularly cleaning skimmer and pump lint baskets.
Guidelines for checking for leaks and the impact of dirty filters.
Advice for identifying and addressing unusual pump noise.
Common pump problems and their corrective actions.
Details on the manufacturer's express warranty terms for Speck pool pumps.
Circumstances under which the warranty may not apply.
Limitations on warranty claims and CWS liability.
Information to be completed for filing a warranty claim.
General| Model | BADU 90/350 |
|---|---|
| Type | Swimming Pool Pump |
| Frequency | 50 Hz |
| Pump Type | Centrifugal |
| Protection Class | IP55 |
| Voltage | 230V or 400V (depending on model) |
| Outlet Connection | 2" (50 mm) |
To Next Page
