What to do if my Speck Swimming Pool Pump motor does not turn on?
If the motor of your Speck Swimming Pool Pump isn't turning, start by verifying that all power switches are on and that the fuse or circuit breaker in the power box is properly set. Also, with the power off, try to turn the shaft. If it doesn't spin freely, it may be jammed and require repair by an authorized repairer.
Why is the flow low in my Speck Swimming Pool Pump?
Low flow in your Speck Swimming Pool Pump could be due to a dirty filter. Backwash the filter or clean the cartridges. Another potential cause is a suction leak. Refer to the troubleshooting steps for 'Pump will not prime' to address suction leaks.
Read and follow all safety instructions carefully before installation and operation to prevent hazards.
Details on optimal pump placement for ventilation, clearance, and proximity to water level.
Instructions for connecting pipes and unions, emphasizing direct runs and proper fitting usage.
Guidelines for connecting the pump to a 230VAC 50Hz supply, including RCD requirements.
Steps for priming the pump, ensuring water presence, and checking connections before operation.
Information on using low and high speeds for filtering, vacuuming, and backwashing.
Includes emptying skimmer/lint baskets, checking for leaks, and filter cleaning.
Instructions for addressing unusual pump noise, advising notification of retailer or technician.
Measures to protect pumps in pebblecrete pools from debris ingress.
Addresses issues like pump not priming, motor not turning, and low flow with possible causes and corrections.
Details on warranty periods for motor and wet end components, and general coverage.
Circumstances under which the warranty may not apply and liability limitations.
Instructions on how to make a warranty claim, including contact information and required documentation.
General| Brand | Speck |
|---|---|
| Model | BADU Super 90 Series |
| Category | Swimming Pool Pump |
| Language | English |
To Next Page
