What to do if the motion detection function is not active on my Speco Security Camera?
If the MOTION DETECTION function of your Speco Security Camera is not active, check the following settings: 1. Ensure the ‘MOTION DET.’ menu is not set to off. 2. Verify the ‘MD LEVEL’ is not set too low. 3. Confirm the ‘MD AREA’ is set properly.
How to fix a Speco HT7246IHR when nothing appears on the screen?
If nothing appears on the screen, ensure the power cord and the line connection between your Speco Security Camera and the monitor are correctly connected. Also, verify that you've properly connected the VIDEO cable to the camera's VIDEO output jack.
Why is the image on my Speco HT7246IHR Security Camera screen dim and how to fix it?
If the image on the screen of your Speco Security Camera is dim, try the following: * Clean the lens with a soft, clean cloth. * Adjust the monitor settings for proper conditions. * Change the camera position if it's exposed to strong light. * Adjust the lens’ focus.
Why is the image on my Speco HT7246IHR screen dark?
If the image on the screen of your Speco Security Camera is dark, adjust the contrast feature of the monitor. If you have an intermediate device, set the 75Ω/Hi-z properly.
What to do if my Speco HT7246IHR is hot and not working?
If your Speco Security Camera is not working properly and the surface is hot, check that you have properly connected the camera to an appropriate power source.
General| Image Sensor | 1/2.8" CMOS |
|---|---|
| Ingress Protection | IP67 |
| Camera Type | Bullet |
| Day/Night | Auto ICR |
| Video Compression | H.265/H.264 |
| Audio Compression | G.711 |
| Network Interface | 10/100Mbps Ethernet |
| Protocol | TCP/IP, HTTP, RTSP |
| Power Supply | 12VDC/PoE (802.3af) |
| Operating Conditions | -30°C ~ 60°C |
To Next Page
