SPECS Globe User Manual (English)

Questions and Answers:

M
Marc CooperJul 29, 2025
Why is the body and bonnet of my SPECS Control Unit broken and leaking?
- J
  Jack Holmes Jr.Jul 29, 2025
  If the body and bonnet of your SPECS Control Unit are broken and leaking, this could be due to a few reasons. One potential cause is water hammer; be careful during operation to prevent sudden stops in pumping or rapid shutdowns. Another reason could be fatigue; replace any valve that's past its guarantee period or shows early signs of fatigue. Lastly, freezing can cause damage, so drain away any water during winter to prevent this.
A
Alan BerryAug 3, 2025
What to do if there is leakage of packing in SPECS Control Unit?
- A
  Alyssa WalkerAug 3, 2025
  If the packing in your SPECS Control Unit is leaking, it could be due to several reasons. The gland flange nuts might be loose, so equally tighten the eyebolt nuts. It's also possible that there aren't enough rings of packing; in that case, add more packing. The packing itself might be old or failing, so consider replacing it. Finally, the stem sealing could be damaged, and the stem shall be maintained periodically by reparation or replacement conjunction with the maintenance of pipeline.
A
akingAug 10, 2025
Why SPECS Globe Control Unit operation failure?
- R
  Richard ReillyAug 10, 2025
  If your SPECS Control Unit is failing to operate, several factors could be responsible. The packing might be too tight; if so, properly loosen the gland flange nuts. Another cause could be that the thread of the stem nut is over worn, so replace the stem nut. Also, the stem could be bent, in that case rectify or replace the stem. Finally, there might be foreign matter between the stem and stem nut or gland, so clean any foreign matter.
C
cgonzalesAug 16, 2025
How to fix leakage between bonnet flanges in SPECS Control Unit?
- J
  joseph52Aug 16, 2025
  If there's leakage between the bonnet flanges of your SPECS Control Unit, it could be because the bonnet bolts are loose; properly tighten the bonnet nuts. Alternatively, the bonnet gasket might have failed, so replace the bonnet gasket.
D
danielandersonAug 22, 2025
What to do if SPECS Control Unit has leakage between sealing surfaces?
- H
  Hunter LarsenAug 22, 2025
  If your SPECS Control Unit is leaking between sealing surfaces, it may be due to dirt between the surfaces; clean the sealing surface. Alternatively, the sealing surfaces could be damaged; in that case, repair the sealing surfaces.